C50.A6010.00E-1
Hardware list
Fan(1)
Loosing four thumb screws to release the M/B tray.
1
2
2
Thumb screw(4)
for HDD extra fixing
5.25"
mounting bracket
3.5"
mounting bracket
Secure the stand-off bolts on the M/B
tray which match with the M/B fix points,
place the M/B on the copper bolt, fasten
the screws to secure.
Screw(31)
to fix drive & motherboard
Copper bolt(12)
for motherboard
Thumb screw(18)
& rubber ring(18)
for fix HDD
REAR
Caution:Both side panels
need to remove first in
order to remove the top
panel
Loosing four screws to remove the
tep panel
14cm fan
with filter
HDD module
Screw(6)
to fix power supply
Case components
3-speed fan
controller
1. Fasten the HDD screws with
anti-vibration rubber rings to the
HDD.
2. Slide the HDD into the HDD cage
with the anti-vibration kit.
Press down the HDD into the slots
to secure.
Adding extra screw to
the HDD cage for extra
security.
Note:
Hard disk installation for modularized HDD cage
12cm fan installation
C50.A6010.00E-2
USB 2.0 flash card reader / writer
CR-36A CR-36B
Support multiple types of memory card
Thermometer
TR-3A TR-3B
Optional kit
Removable PSU tray
3-speed fan adjustable
device
/
