OSP Furniture KEN-56-MAH Operating instructions

Type
Operating instructions

This manual is also suitable for

STEP 1
STEP 4
(1)Top (2)End Panel (3)End Panel (4)Shelf (5)Fixed Shelf (6)Fixed Bottom (7)Back Panel (8)
Bottom Rail
(A)Dowel (B)Cam Pin (C)Cam Lock (D)Leg Leveller (E4)Wood Screw (S1)Corner Bracket
1PC 3PCS
16PCS+1 12PCS+1 12PCS+14PCS12PCS+1 12PCS+1 16PCS+2 4PCS
(A)
(D)
(D) (D)
(D)
(1)
(B) (2) (3)
(5) (6) (8)
(C)
(G)Shelf Pin
STEP 2 STEP 3
STEP 5 STEP 6 Bookcase 70 H
KEN-56
36 W ×14 D×70 H
Always lay components on A clean,
soft-cushioned surface during assembly.
877-OSP-WORX
(677-9679)
(p)Adhesive
Cam Coverr
1PC 1PC 1PC 1PC 1PC1PC
(B)
(B)
(B)
(A)
(C)
(B)
(B)
(B)
(B) (B)
(B)
(B)
(B)
(A)
(A)
(C)
(C)
(A)
(A)
(A)
(A)
(C)
(C)
(C)
(C)
(C)
(C)
(C)
(C)
(A)
(A)
(A)
(A)
(A)
(A)
(A)
(A)
(G)
(G)
(G)
(G)
(G)
(G) (G)
(G)
(G)
(G)
(G)
(G)
STEP 8
(4)
(4)
(2)
STEP 9
(7)
STEP10
(1)
(4)
(8)
(6)
STEP 7
(5)
(B)
(3)
(B)
(5)
(3)
Bookcase 70 H
KEN-56
36 W ×14 D×70 H
Always lay components on A clean,
soft-cushioned surface during assembly.
(S1)
(E4)
877-OSP-WORX
(677-9679)
(F)
(F)
(F)Wall-attachment kits
1PC
STEP 11
Bookcase 70 H
KEN-56
36 W ×14 D×70 H
Always lay components on A clean,
soft-cushioned surface during assembly.
877-OSP-WORX
(677-9679)
1.Affix 1st wall-attachment bracket to the top of Bookcase,
at rear/center, using(2) SHORT screws.
2.Affix 2nd wall-attachment bracket to the wall,
using(2)wall anchors and(2) LONG screws.
Note: Locate the 2nd bracket 1/4” higher than the 1st
bracket(now located on the top of the bookcase). Align 2nd
bracket left/right with the 1st bracket.
3.Connect wall-attachment brackets with plastic cable tie.
  • Page 1 1
  • Page 2 2
  • Page 3 3

OSP Furniture KEN-56-MAH Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI