Quick Start Guide
START HERE
It is strongly recommended that you follow
these step by step instructions to set up
and quickly start to use your Xcelerator IP
gateway.
You will need the following parts to complete the installation of your Xcelerator IP
Documentation
XCELERATOR IP GATEWAY
ANTENNA
AC POWER ADAPTER
DOCUMENTATION CD
1
UNPACKING THE BOX CONTENTS
2
INSTALLING THE XCELERATOR IP GATEWAY
If the Xcelerator IP gateway is to be wall mounted, print a
copy of the wall mount template from the documentation CD
for use in lining up the screw mounts with the mounting holes
in the gateway. To mount the Xcelerator IP on a table or other
flat surface, insert the Xcelerator IP gateway unit into the
provided stand.
Next, mount the antenna to the threaded connection on the
upper side of the Xcelerator IP gateway chassis. Once
mounted, the antenna must be fully extended for proper
operation as depicted in the diagram.
GATEWAY STAND
3
POWER THE XCELERATOR IP GATEWAY
Once the Xcelerator IP has been mounted, attach the AC power adapter to the “Power In” connector on the interface
panel of the gateway. Plug the AC power adapter into a grounded 120VAC power source. Move the ON/OFF switch
to the ON position.
A blue LED above “Power” on the front of the Xcelerator IP will indicate the gateway is powered and ready to
continue with the installation of the unit.
4
STARTING TO USE THE XCELERATOR IP
Open your internet browser and type in 192.168.1.1. This is the default
address of the Xcelerator IP Admin interface. The default password is
“admin” and the default user name is “admin”.
On new installations, or if the system is defaulted, the Xcelerator IP will start with a configuration Wizard to assist
with the installation. Refer to the Administrator Guide for details on the programming of the Xcelerator IP.
P/N 7552-00
Attach a PC or laptop to the Xcelerator IP via one of the Ethernet ports or via
a wireless connection.
5
CONNECTIONS
A detailed description of the operation of these ports can be found in the Administrator Guide on the documentation
CD included with the Xcelerator IP gateway.
RJ45 Wide Area
Network connection
for cable modem/
DSL modem
10/100baseT
Connectors for
IP2007 phones or
Ethernet switch
Note: Refer to the IP2007 User
Guide for installation and use of the
IP2007 telephone
RJ11
Connector for
Analog SLT
phone or fax
machine
Analog CO
Telephone lines
AC Power
connector
ON/OFF
Switch
6
STATUS INDICATORS
The Xcelerator IP status LED lamps provide real time indicators of the operation of the gateway and can be used to
assist with troubleshooting.
When the specific lamp is lit, it is indicating:
Power ON
Wireless Access Point is active
TELCO Trunk is in use
Analog SLT port is in use
WAN port
connected
Transmission and receipt of
data on the individual ports
Switch or
POE Switch
IP2007 can be
connected to
Xcelerator IP
or hub/switch
Standalone
PCs can be
routed
through the
Xcelerator IP
The IP2007 contains a 10/100 switch which allows for
connecting a PC to the network via the phone’s Ethernet
connection
/
