Application Sheet
Lit. No.
VY7FI102
Date:
2000-02-04
ECL2000 with LON Heat Meter
ECL 2000
Terminator
LON
Bindings
Heat Meter
To other equipment or
Main station
The limiter function enables the ECL 2000 to
reduce or increase the flow temperature
in the heat circuit in accordance with various
parameters being measured by the control-
ler. The available limiter functionality de-
pends on what sensors are connected to the
ECL 2000.
The energy limiter function in the ECL 2000
is available when the data from an energy
sensor (e.g. heat meter with LON interface)
is directly connected via a LON network to
one of the available LON inputs L1, L2, L3 or
L4 at the ECL 2000 and the relevant SNVTs
are bound.
The data for accumulated energy is auto-
matically transferred and collected in the
ECL 2000 together with the data for actual
energy.
The energy limiter function is also available
for the hot-water circuit.
When the energy consumption exceeds a
user-defined set-point (max. limiting), the
hot-water temperature can be modified
(typically reduced).
Parameters for the energy limiter are set up
in the ECL 2000 service menu.
The data received from the heat meter via
the LON network is upon request or if
bound, transmitted to other LON devices or
to a SCADA system / main station.
What do I need?
For binding SNVTs:
• PC (Laptop)
• Interface between LON network and the PC
• Binding tool
For visualisation of network data:
• SCADA system, main station or PC (Laptop) with e.g. visualisation software and an OPC-
server
/