SUSSEX BTRD700 Installation guide

Type
Installation guide
1
2The Brass Wall Fixing must be mounted with
the holes in the Horizontal position as shown.
Horizontal Vertical
Left Extension
Right Extension
Fastening
Screw x 4
Tox Plug
x4
Brass Wall
Fixing x 2
6.5mm Drilled
Holes x 4
RAIL RETAINING
SCREWS X 2
Rail
Rail
RAIL RETAINING
SCREW
RAIL RETAINING
SCREW
STAINLESS STEEL
SET SCREWS X 2
STAINLESS STEEL
SET SCREWS X 2
APPROX. 700/900mm Centres
Product code
Installation guidelines
Suba
- Before installing ensure work area is clean and free of any obstacles.
- Carefully unpack to identify the parts and assemble on a non-scratch surface.
- Using the supplied 2mm Allen Key, loosen the Stainless Steel Set Screws within the Extensions and remove
the Brass Wall Fixings.
- Combine the Rails with both Extensions and measure to confirm the exact centre distance between
the Extensions.
- Choose the desired location for mounting and mark-out measured centres. Add 1 or 2 mm to ensure final fit
of the Double Towel Rail.
- Centralize the Brass Wall Fixings onto the marked-out positions and transfer drilling holes.
BTRD700 Towel rail double 700mm
BTRD900 Towel rail double 900mm
Towel rail double
Note
- The Brass Wall Fixings must be mounted with the Holes in the Horizontal direction. (see Fig.2)
- Drill 6.5mm holes, fit Tox Plugs and secure the Brass Wall fixings using the Fastening Screws.
- Fit the Double Towel Rail over the Brass Wall Fixings as a combined assembly. (Rails with Extensions)
- Ensure the Extensions are aligned square and tighten the Stainless Steel Set Screws.
- To complete the installation tension the Rail retaining screws to fix the Rails.
sussextaps.com.au
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c
Copyright © Sussex Taps.
  • Page 1 1

SUSSEX BTRD700 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI