2. SUSSEX
  3. BTRH
BTRH

SUSSEX BTRH Installation guide

  • I've reviewed the user manual for the Sussex Toilet roll holder BTRH. This document provides clear instructions on how to install the pre-assembled toilet roll holder, emphasizing the importance of horizontal mounting for the brass wall fixing. I'm ready to answer any questions you might have about the installation process or features of this device.
  • What tool is needed to loosen the Stainless Steel Set Screws?
    In what direction should the Brass Wall Fixing be mounted?
    What size drill bit is needed for the installation?
1
2The Brass Wall Fixing must be mounted with
the holes in the Horizontal position as shown.
Horizontal Vertical
Tox Plug
x 2
Brass Wall
Fixing
Fastening
Screw x 2
6.5mm Drilled
Holes x 2
STAINLESS STEEL SET SCREWS x 2
Extension
Product code
Installation guidelines
Suba
- The Toilet Roll Holder is supplied pre-assembled within its packaging.
- Using the supplied 2mm Allen Key, loosen the Stainless Steel Set Screws and remove the Brass Wall Fixing
from the Extension.
- After choosing the fixing location, use the removed Brass Wall Fixing to mark-out the drilling holes.
BTRH Toilet roll holder
Toilet roll holder
Note
- The Brass Wall Fixing must be mounted with the Holes in the Horizontal direction. (see Fig.2 )
- Drill the 6.5mm holes, fit Tox Plugs and secure the Brass Wall Fixing using the Fastening Screws.
- Fit the Toilet Roll Holder over the Brass Wall Fixing, aligned square, and tighten the Stainless Steel Set Screws.
sussextaps.com.au
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c
Copyright © Sussex Taps.
/