BTRS700

SUSSEX BTRS700 Installation guide

  • Hello! I've reviewed the installation guidelines for the SUSSEX towel rail, which comes in 700mm and 900mm sizes. I'm ready to assist you with any questions you have about the installation process, including the use of the brass wall fixings, the stainless steel set screws, and the correct drilling size.
  • What size drill bit is needed for installation?
    In which orientation should the brass wall fixings be mounted?
    What tool is needed to loosen the stainless steel set screws?
1
2The Brass Wall Fixing must be mounted with
the holes in the Horizontal position as shown.
Horizontal Vertical
Left Extension
Right Extension
STAINLESS STEEL SET SCREWS x 2
RAIL RETAINING SCREWS X 2
Rail
Fastening
Screw x 4
Tox Plug
x4
Brass Wall
Fixing x 2
6.5mm Drilled
Holes x 4
STAINLESS STEEL SET SCREWS x 2
APPROX. 700/900mm Centres
Product code
Installation guidelines
Suba
- Before installing ensure work area is clean and free of any obstacles.
- Carefully unpack to identify the parts and assemble on a non-scratch surface.
- Using the supplied 2mm Allen Key, loosen the Stainless Steel Set Screws within the Extensions and remove
the Brass Wall Fixings.
- Combine the Rail with both Extensions and measure to confirm the exact centre distance between
the Extensions.
- Choose the desired location for mounting and mark-out measured centres. Add 1 or 2 mm to ensure final fit
of the Single Towel Rail.
- Centralize the Brass Wall Fixings onto the marked-out positions and transfer drilling holes.
BTRS700 Towel rail single 700mm
BTRS900 Towel rail single 900mm
Towel rail single
Note
- The Brass Wall Fixings must be mounted with the Holes in the Horizontal direction. (see Fig.2)
- Drill 6.5mm holes, fit Tox Plugs and secure the Brass Wall fixings using the Fastening Screws.
- Fit the Single Towel Rail over the Brass Wall Fixings as a combined assembly. (Rail with Extensions)
- Ensure the Extensions are aligned square and tighten the Stainless Steel Set Screws.
- To complete the installation tension the Rail retaining screws to fix the Rail.
sussextaps.com.au
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c
Copyright © Sussex Taps.
/