Place the KD Cams into the
holes indicated in your assembly
instructions.
(See picture A)
• Insert the KD Cam into the hole with the
arrow pointing towards the hole.
Take the piece containing the KD
Cams and slide it onto the KD Bolts
attached to the appropriate side
panels, as indicated in your
assembly instructions.
(See picture B)
Tighten the KD Cams completely
to finish this portion of the
assembly.
(See picture C)
• The KD Cam should be tightened by
turning from 190 to 230 degrees.
C
B
A
1
2
3
HOW TO Tighten KD Cams
Click here or scan this QR Code to watch the video!
• (DO) Use a soft, lightly dampened
cloth to remove smudges and
dust from your work surface.
• (DO) Use soap and water.
• (DO) Wring the cloth out before
cleaning the work surface.
A
HOW TO Clean the Surface
Click here or scan this QR Code to watch the video!
• (DO NOT) soak the work surface.
• (DO NOT) use furniture polish.
HOW TO Separate and Install Drawer Slides
1
Extract each runner from
its mount and cage.
• Fully extend the slide and push
up on the lock lever. (See picture A)
• Grab the runner and pull it out
from the mount and cage.
• Set runner aside for now.
• Repeat for other runner.
Prior to installation, your drawer slides must first be separated.
Follow these simple steps to separate and properly attach your slides.
Fasten the Mount and Cage pieces
to the inner upright cabinet panels.
• Extend the slide and fasten the screws
into the proper holes as indicated in your
assembly instructions (See picture B)
• Fully open the slide and install the screw
closest to the slide end.
• Adjust the slide position to insert the
remaining screws. (See picture C)
• Repeat for other side.
2
Complete drawer slide assembly.
• Fasten runners to the sides of your drawer
as indicated in the assembly instructions.
• Slide the drawer into the mount and cage
pieces attached to the inside of the cabinet.
(See picture D)
3
D
B
A
C
Click here or scan this QR Code to watch the video!
/
