Hubbell TD06136E_Cross_Plate_Anchors Installation guide

Hubbell
Brand
Hubbell
Model
TD06136E_Cross_Plate_Anchors
Type
Installation guide
CROSS PLATE ANCHORS
Application/Installation
hubbellpowersystems.com
ANCHOR
APPLICATIONS
For medium and heavy transmission guying. Installed in machine bored holes.
Load-based on using a 400 square inch anchor to a 24” hole.
INSTALL IN THESE
CLASS SOILS
Classes 3, 4, 5, 6 and 7 (100-600 inch-pound with the soil test probe)
INSTALLING
EQUIPMENT
REQUIRED
Power digger, rod trenching tool, shovel and tamping bar.
LIMITATIONS
ON USE
Necessity of undercutting hole limits anchor depth. Rod trench should not be
large or holding capacity will be reduced. Both anchor hole and rod trench
must be backfilled and tamped.
STEP #1
Drill a vertical or angled hole.
STEP #2
Undercut the hole so that the anchor plate can be
installed at a right angle to the guy.
STEP #3
Cut a rod trench with a trenching tool or a
small auger.
NOTE: Trench should be narrow to avoid
disturbing soil.
STEP #4
Assemble rod to anchor and install the anchor inside
the hole so that the rod is aligned within ±5° of the
guy.
NOTE: Improper alignment may reduce holding
capacity.
Undercut
HOW TO USE CROSS PLATE ANCHORS
©2019 Hubbell Incorporated.
Because Hubbell has a policy of continuous product improvement,
we reserve the right to change design and specifications without notice.
Printed in the U.S.A. | TD_06_136_E
For product inquiries, please contact your local sales
representative or customer service representative.
hubbellpowersystems.com
STEP #5
Thoroughly backfill and tamp the anchor hole and rod trench.
Rod Slot
TOP VIEW
  • Page 1 1
  • Page 2 2

Hubbell TD06136E_Cross_Plate_Anchors Installation guide

Hubbell
Brand
Hubbell
Model
TD06136E_Cross_Plate_Anchors
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents