2. Crystorama
  3. EMO-5407-BF
EMO-5407-BF

Crystorama EMO-5407-BF User manual

  • Hello! I have reviewed the assembly instructions for the Crystorama EMO-5407-BF light fixture. This document describes the steps for mounting the fixture, installing the glass drops, and preparing the lighting for use. The fixture is designed for damp locations and requires 6 candelabra base bulbs. I'm ready to answer any questions you may have about this device and the provided instructions.
  • What type of bulbs are required for this fixture?
    Is this fixture suitable for damp locations?
    What is the maximum wattage for the bulbs?
ASSEMBLYINSTRUCTIONMODEL#EMO-5407-BF
CRYST
RAMA
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
WARNING:
ElectricalDanger TurnPoweroff
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Youwillneed6-CandelabraBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
This fixture is Damp rated
(W1’’xL7-7/8’’)x102sets
Howtoinstall
8.Installthebulbs(notincluded)intothesocket.
1.Feedthewiresthroughthestem.Slipthedownrod
alongwireandthreaditontothenippleontopof
frame.
STEM
LOOP
CHAIN
LOOP
BANDING
RING
GLASSDROP
NIPPLE
WALL ANCHOR
OUTLET BOX SCREW
MOUNTING PLATE
ANCHOR SCREW
MOUNTING SCREW
CANOPY
23-3/4’’
27-1/2’’
3/4’’
5’’
49’’
7-1/4’’
97-1/4’’
FRONTVIEW
SIDEVIEW
2.Placethemountingplateovertheoutletbox.Mark
fourpointsontheceilingatthecenterofthekeyhole
onthemountingplate.
3.Drillfourholesatthemarkedpointsandinsertthe
wallanchors.
4 Placethemountingplateovertheoutletboxand
secureitwithtwooutletboxscrews.Insertthe
anchorscrewsintothewallanchors
(Installedinstep#3)andtighten.
.
5.Determinethepreferredhangingheightandadjustto
thechainrequired.
6.Installcanopyontothemountingplate,andsecure
withthemountingscrews.
7.Hangglassdroptothebandingring.
Crystorama.com
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
PartNumber
ASSEMBLYINSTRUCTIONMODEL#EMO-5407-BF
A
B
C
D
E
F
G
H
I
PartNumbers
A.(1)-Mountinghardware
I.(102)-GlassdropW1’’xL7-7/8’’
B.(1)-Mountingplate
C.(6)-Mountingscrew
D.(1)-CanopyW5’’xL27-1/2’’xH3/4’’ #XRF5407BFCAN5IN
E.(1)-Chain-L72’’,3.8mmthick#XRF5407BFCHA3.8MM
F.(2)-StemW1/2’’xL12-3/4’’ #XRF5407BFROD12.75IN
H.(6)-Socket
G.(1)-Bandingring#XRF5407BFRING
Crystorama.com
/