2. ITC
  3. 85606-SS

ITC 85606-SS Installation guide

  • Hello! I'm your chat assistant. I've reviewed the installation instructions for the 85606-SS Assist Handle. This document outlines the steps for secure mounting to structural support using your own screws and a power drill. I'm here to help you with any questions you may have about this product or the installation process.
  • What screws are needed for installation?
    What tools are required for installation?
    What should I ensure when choosing installation location?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Determine installation location. Make sure there is structural support behind the handle. Failure to
install into adequate support will void the warranty and run the risk of pulling the handle out of the
wall.
PARTS NEEDED:
Assist Handle 5/16-18 SS Mounting Screws
(not provided) Power Drill
1. Mark screw holes, then drill pilot holes. 2. Place handle over holes and install using
5/16-18 stainless steel screws (not provided).
INSTALLATION INSTRUCTIONS
7” Stainless Steel
Assist Handle
Part#: 85606-SS
For warranty information please visit www.itc-us.com/warranty-return-policy
Rev A • 08/29/18
Page 1 of 1
/