2. BLOTZ
  3. B10-MW-016

BLOTZ B10-MW-016, B10_MW_016 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ 10mm Small Ruin model B10-MW-016. This document describes the step-by-step process, including which tools and materials you will need. I'm ready to answer any questions you have about the assembly process.
  • What type of glue is needed for assembly?
    What tool is required to remove the pieces from the sprue?
    What can be used to clean the joints?
    Can I use something to hold pieces while glue dries?
10mm Small Ruin #1
B10-MW-016
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the front wall, central wall and upper floor pieces
from the sprue.
Glue the central wall and floor pieces to the back of
the front wall as shown.
Take the two side walls…
..and glue these into place.
Glue this whole assembly to the base.
Then add the two small back walls.
The completed ruin.
/