Legrand PLC Transceiver Kit - 363438-01 Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

PLC Transceiver Kit

IS-0008 REV. B

1. INTRODUCTION

The On-Q/Legrand Power Line Carrier Transceiver Kit, P/N

363438-01, may be used with On-Q’s Home Lighting Controller

or any On-Q HMS Controller to enable the controller to transmit

power line carrier (PLC) signals throughout the home.

The kit (see Figure 1) includes the following:

1 – PLC Interface (Plug-In Cube)

1 – 6P4C Modular Cable (reversed end-to-end)

2. INSTALLATION (see Figure 2)

Step 1: Plug the supplied PLC Plug-In Cube into a 120VAC

outlet in the house.

Step 2: Plug one end of the supplied modular cable into the

Plug-In Cube and the other end into the X-10 jack on the

appropriate controller.

Step 3: The LED on the Plug-In Cube should be on and blink off when the Interface receives a signal from the controller or

from any other X-10 source.

3. Warranty

On-Q/Legrand warrants to the end-user, each new switch to be free of defects in materials or workmanship for a period of

one year from the date of original purchase from On-Q/Legrand or its authorized reseller or installer. Each product is

deemed warrantable under conditions of normal use and when installed and operated within On-Q/Legrand specifications

and in accordance with the applicable National Electrical Code and Safety Standards of Underwriters Laboratories. When

determined to be warrantable, On-Q/Legrand shall at its option and expense, replace any defective product with a new or

reconditioned product. On-Q/Legrand will continue to warrant any replaced product for a period of ninety (90) days from

shipment, or through the end of the original warranty period, which ever is longer.

Figure 2

PLC Transceiver

Kit P/N 363438-01

ure 1