Liquid-cooling
system tube vents
rubber cover
C50.B1000.01E-1
Case components
Place the water tube through
the rubber cover.
Vents for water cooling
Door key is attach to
the accessory box
Front door
with lock
140mm fan
HDD module
Patented
tool-less 5.25”
device mounting
Side panels installation
Loose the screw and pull the
latch to release the side panel.
Remove the side panel.
1
2
120mm fan
Hardware list
Thumb screw(2)
for HDD cage
Screw(8)
for HDD cage
Cushion(4)
(5)
(20)
1. First, remove HDD holder from
HDD cage.
2. Open the HDD holder's clip.
3. Insert HDD into HDD holder,
close the clip to secure.
4. Slide the HDD holder into the
HDD cage.
Hard disk installation
Note:
Adding cushion to hold
slim vision 3.5" HDD in
HDD holder.
Note:
Adding extra screw to
the HDD cage for extra
security.
1
Push to release
ODD installation
Release the mounting bracket.
Push the CD-ROM into the ODD
module.
2
Close the bracket.
2
Patented
tool-less PSU
mounting
bracket
Patented
Tool-less PCI
add-on card
holder
1
for cable management
Use the HDD holder bracket to
secure the holder in place.
Note
Clamp
Thumb screw(6)
for mount
Thumb screw(3)
for mount
Please visit www.lian-li.com for FRANCE / GERMANY / SPAIN user's manual
Veuillez visiter www.lian-li.com pour le manuel d’installation en FRANÇAIS/ALLEMAND/ESPAGNOL.
Visite el sitio Web www.lian-li.com para obtener el manual del usuario en FRANCÉS ALEMÁN Y ESPAÑOL
Besuchen Sie bitte www.lian-li.com für die französische/ deutsche/ spanische Gebrauchsanleitung
Installation Guide
Bracket(1)
to fix power supply
HDD holder brack(1)
Just press plastic handle
C50.B1000.04E-2
PSU installation
Ventilator for PCI slot installation
Finish.
POWER SW
RESET SW
POWER
LED
H.D.D LED
SPEAKER
WHITE
GRAY
WHITE
BLUE
WHITE
NC
GREEN
WHITE
ORANGE
BLACK
NC
NC
RED
GROUND
PWR
GROUND
Reset
PLED-
PLED+
IDE_LED-
IDE_LED+
Speaker
+5V
Front panel cable
installation guide
1
2
Release the mounting bracket. Push the card into the PCI add-on
card module, close the bracket.
Place the PSU on the stand,and push again
the rear panel.
Place the PSU bracket into according slot as
shown.
Lock the PSU bracket to secure the PSU.
* For transportation, please place screw to secure
the PSU
AC 97AUDIO
Accessing fan filter
Take the spindles off
the top and bottom
plate
Loosing two screws as shown
above to release the door.
Remove the door.
Release the four screws at the side of
the side panel to remove it.
Press the handle to release the washable
air filter.
Cable management note
Use cable clamp to tidy up the cables.
Secure the stand-off on the M/B tray which match
with the M/B fix points, place the M/B on the stand-off
fasten with the thumb screws to secure.
!
Note: For area where hard
to reach use the
long thumb screw
!
!
* Remove clamp, use
tweezers to release the
cable clamp
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
