Lian Li PC-P50B Datasheet

Category
Computer cases
Type
Datasheet

This manual is also suitable for

Liquid-cooling
system tube vents
rubber cover
C50.P5000.01E-1
Case components
Place the water tube through the
rubber cover.
Vents for water coolingSide panels installation
Hardware list
Cushion(3)
for HDD module
(5)
1. First, remove HDD holder from
HDD cage.
2. Open the HDD holder's clip.
3. Insert HDD into HDD holder,
close the clip to secure.
4. Slide the HDD cage into the
HDD rack.
Hard disk installation
Note:
Adding cushion to hold slim vision
3.5" HDD in HDD holder.
Note:
Adding extra screw to the HDD cage
for extra security.
ODD installation
1
for cable management
Thumb screw(6)
for mounting motherboard
Thumb screw(3)
for mounting motherboard
Please visit www.lian-li.com for FRANCE / GERMANY / SPAIN user's manual
Veuillez visiter www.lian-li.com pour le manuel d’installation en FRANÇAIS/ALLEMAND/ESPAGNOL.
Visite el sitio Web www.lian-li.com para obtener el manual del usuario en FRANCÉS ALEMÁN Y ESPAÑOL
Besuchen Sie bitte www.lian-li.com für die französische/ deutsche/ spanische Gebrauchsanleitung
Installation Guide
Bracket(1)
to fix power supply
140mm fan x 2
120mm fan
Patented
tool-less 5.25”
device mounting
Patented
tool-less PSU
mounting
bracket
Clamp
Patented
Tool-less PCI
add-on card
holder
120mm fan
Patented
HDD module
Just press plastic handle to
release the mounting bracket.
Push the CD-ROM into the ODD
module, close the bracket.
Press the right and left
side of the bezel to
remove
Pull the front panel toward
yourself.
bezel
3
Removable air filter
Hex wrench(1)
for M/B copper bolt
2
Rubber ring(1)
(24)
s
Round head screw(3)
for HDD rack
Flat head screw(3)
for HDD rack
Copper bolt(9)
for motherboard
Secure the 2.5” HDD
fo the base of the case
sit below 3.5" HDD
* PC-P50/R and C-02 are not compatible
Slide panel backward of the case. Lift up the side panel.
Buzzer wire(1)
Cable tie(2)
Rubber ring(1)
PC-P50R
PC-P50
1
C50.P5000.01E-2
PSU installation
Cable management note
Ventilator for PCI slot installation
Finish.
POWER SW
RESET SW
POWER
LED
H.D.D LED
SPEAKER
WHITE
GRAY
WHITE
BLUE
WHITE
NC
GREEN
WHITE
ORANGE
BLACK
NC
NC
RED
GROUND
PWR
GROUND
Reset
PLED-
PLED+
IDE_LED-
IDE_LED+
Speaker
+5V
Front panel cable
installation guide
1
2
Release the mounting bracket. Push the card into the PCI slot
close the bracket.
Place the PSU on the stand, and push again
the rear panel.
Place the PSU bracket into according slot as
shown.
Lock the PSU bracket to secure the PSU.
* For transportation, please place screw to secure
the PSU
Use cable clamp to tidy up the cables.
Secure the stand-off bolts on the M/B tray which
match with the M/B fix points, place the M/B on the
copper bolt, fasten with the thumb screws to secure.
AC 97AUDIO
!
Note: For area where hard
to reach use the
long thumb screw
!
!
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Lian Li PC-P50B Datasheet

Category
Computer cases
Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI