HOZAN F-67-S / M / L Owner's manual

Brand
HOZAN
Model
F-67-S / M / L
Type
Owner's manual

HOZAN F-67-S / M / L are ESD gloves designed to protect the user from electrostatic discharge. They are made of a combination of materials, including PVC, nylon, and conductive yarn, and are available in three sizes: small, medium, and large. The gloves are green in color and have a weight of 26 grams. The overall length of the gloves is 215 millimeters.

The HOZAN F-67-S / M / L gloves meet the ESD standard of charge decay from 1000V to 100V in less than 2 seconds. They are also antistatic and can be washed with lukewarm water and dried in the shade after towel drying. For sebum stains, a neutral detergent can be used. Bleach, fabric softener, or disinfectant spray should not be used.

HOZAN F-67-S / M / L are ESD gloves designed to protect the user from electrostatic discharge. They are made of a combination of materials, including PVC, nylon, and conductive yarn, and are available in three sizes: small, medium, and large. The gloves are green in color and have a weight of 26 grams. The overall length of the gloves is 215 millimeters.

The HOZAN F-67-S / M / L gloves meet the ESD standard of charge decay from 1000V to 100V in less than 2 seconds. They are also antistatic and can be washed with lukewarm water and dried in the shade after towel drying. For sebum stains, a neutral detergent can be used. Bleach, fabric softener, or disinfectant spray should not be used.

ᾀᴾ
Thank you for purchasing the HOZAN F-67-M ESD GLOVES, MEDIUM. With proper care
and handling, these fine instruments will provide years of trouble-free operation. Please
read this entire instruction manual carefully before attempting to place these instruments in
service. Please keep this instruction manual available for reference.
ESD GROVES, MEDIUM (10pairs/pack)ᴾ
F-67-M
INSTRUCTION MANUALᴾ
26 gᴾ
Greenᴾ
Cleats: PVC
Other than cleats:
Nylon, Conductive yarn
(Carbon fiber) ᴾ
Weight
Materialsᴾ
Color (wrist)ᴾ
ESD standard
Charge decay from
1000V to 100V in less
than 2 secs.
Size
OAL 215 mmᴾ
Mᴾ
1. Do not use on energized places. This
could cause a shock.
2. Do not bring the product into contact with
liquid or something hot.
3. If you have any allergic reaction, stop
using and consult a doctor at once. ᴾ
ᴾWarning
ᴾPrecautionsᴾ
Carry out periodic inspections to maintain
ESD protective performance. ᴾ
ᴾCaution
ᴾSpecificationsᴾ
ᴾDaily Careᴾ
Wash with lukewarm water, dry in the
shade after towel drying
Use a neutral detergent for sebum stains.
Do not use bleach, fabric softener, or
disinfectant spray.
ᴾAntistatic standardsᴾ
HOZAN’s ESD-safe products are controlled with reference to the Japanese
standard (RCJS-5-1 *1) which is based on the international standard (IEC61340-5-
1).ᴾ
Products which bear the “ “ mark are products to which the standard values
(see table below) apply. The “ESD Standard” listed on each of the product pages
denote the HOZAN standard for the product.ᴾ
Where foot grounder and floor system are employed as personal grounding device,
the grounding resistance must be determined by the ESD coordinator. The
recommended value is 7.5 X 105 to 3.5 X 107Ω. ᴾ
Less than 2 secs. from
initial value (Max.
1000V) to 10%
ESD-safe item requirements
(Excerpted from RCJS-5-1)
ẔItem-specific requirementsẕ
Charge decay
*2
Gloves and
finger cots
EPA ground resistance
or Resistance Rg(Ω) of
groundable point
Gloves and finger sacks
that satisfy the system requirements.
Using gloves
and finger cots 7.5ᶣ105ṓRg
ᾋ1ᶣ1012
ẔSystem requirementsẕ
*2Ḡᴾ
*1Ḡᴾ
Reliability Center for Electronic Components of Japan (RCJ).
“Protection of Electronic Devices from Electrostatic Phenomena-General Requirements” (RCJS-5-1)ᴾ
Dimensions may fluctuate somewhat
for cloth products.
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
https://www.hozan.co.jp/E/ E-mail th@hozan.co.jp
23.08
  • Page 1 1

HOZAN F-67-S / M / L Owner's manual

Brand
HOZAN
Model
F-67-S / M / L
Type
Owner's manual

HOZAN F-67-S / M / L are ESD gloves designed to protect the user from electrostatic discharge. They are made of a combination of materials, including PVC, nylon, and conductive yarn, and are available in three sizes: small, medium, and large. The gloves are green in color and have a weight of 26 grams. The overall length of the gloves is 215 millimeters.

The HOZAN F-67-S / M / L gloves meet the ESD standard of charge decay from 1000V to 100V in less than 2 seconds. They are also antistatic and can be washed with lukewarm water and dried in the shade after towel drying. For sebum stains, a neutral detergent can be used. Bleach, fabric softener, or disinfectant spray should not be used.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents