28mm Search Light
B28-SF-207
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Search Light (B28-SF-207)
Remove the five rings and two supports (shown
above) from the sprue.
Glue the supports to the base piece, then attach (in
order) a hollow ring, the ring with the central circle, a
hollow ring, the top ring).
Take the two uprights and end caps from the
sprue.
Slide the uprights over the arms and attach an end cap
to each.
NB: Only glue the end caps – allow the uprights to
swing freely.
Take the four legs and base from the sprue.
Glue the legs to the base as shown.
Take the remaining pieces from the sprue.
Glue the long piece to the uprights and attach the
cross underneath it as shown.
Slide the base onto the cross and position the
washer before clueing the final end cap into
position.
NB: Do not glue the washer or base to the cross –
only the end cap.
The finished aearch light.
/
