WPD 100 AV Series Wallplates • Installation Guide
The Extron WPD 100 AV Series Wallplates are one-gang
pass-through wallplates with rear mounted audio connectors,
control connectors, and video cable pigtails. All models can be
installed in US standard one-gang junction boxes, and include a
decorator-style frame.
WPD 110 A
AB
HDMI
C
e
Planning - Check the Proposed Installation Location
Before starting the installation, it is important that you do the following:
CAUTION:
• Failure to check the items listed below may result in personal injury.
• La non-vérification des éléments listés ci-dessous peut provoquer des blessures.
ATTENTION:
• Failure to check the items listed below may result in property damage.
• La non-vérification des éléments listés ci-dessous peut provoquer des dommages
matériels.
Ensure there are no utility cables or pipes at the intended location that may be damaged
or cause injury when installing the module.
Check that the installation meets the local and state regulatory requirements, including
building, electrical, and safety codes, and UL and ADA accessibility requirements.
NOTE: During installation, ensure the space
behind the module is sufficient for cable
bend radius and cable management.
Minimum Bend Radius
4.10"
(104 mm)
2.40"
(60 mm)
1.60"
(41 mm)
4
.1
0"
(10
4
C
e
HDMI
ABC
WPD 100 AV Series Wallplates • Installation Guide
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related
topics, see the Extron Safety and Regulatory Compliance Guide on the Extron website.
© 2014-2021 Extron — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
Installation
Wall Box Flush with
Wall Surface
Cut out the area
for the mud ring or
wall box.
Thread the cables
through the mud
ring or wall box.
Insert the appropriate
connectors into the
WPD ports.
Secure the WPD to the
Mud Ring/Wall Box and
attach the supplied
decorator-style frame.
Insert the mud ring or wall
box into the opening and secure it.
Mud Ring Wall Boxor
Extron
WPD 100 AV
Minimum Bend Radius
C
HDMI
A
B
C
C
HDMI
A
B
C
Sleeve (S)
Ring (R)
Tip (T)
3.5 mm Audio Jack
T
R
S
4
4.10"
(104 mm)
2.40"
(60 mm)
1.60"
(41 mm)
C
e
HDMI
A B C
Audio Wiring
The included 3-pole captive screw audio connector can be wired
for either balanced mono audio or unbalanced stereo audio, as
described below (see the figure at right). Then secure the output
audio cable into the 3-pole captive screw port.
• For balanced mono audio:
tip (T) = +, ring (R) = -, sleeve (S) = ground
• For unbalanced stereo audio:
tip (T) = left channel, ring (R) = right channel,
sleeve (S) = ground
Slee
ve (S)
Ring (R)
Tip (T)
3.5 mm Audio Jack
T
R
S
68-2279-01 Rev. F
01 21
/
