Assembly Instructions
Component parts:
Assembly:
1
Hardware Needed: All hardware is stainless steel.
Contact Us:
800.231.1327
1. Inspect the shipping container contents for damaged or missing components.
2. Lay all parts on a so work surface or on the shipping packaging to prevent damage to nish.
NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to screw threads.
Tools Needed:
• 3/4” Hex Wrench
• 3/4 Hex Socket with Ratchet
• Retractable Measuring Tape
• Pencil
T1038T - 8’ Rectangular Thermory® ADA Picnic Table
T1038R - 8’ Rectangular Recycled Plastic ADA Picnic Table
Traditional Picnic Tables
(4) Table Supports (1) Table Top
(1) Long Bench
(2) ADA Bench
(4) Cross Braces
(32) 5/16"-18 x 1 1/4"
Hex Head Bolts
(32) 5/16-18
Nylock Nuts
(64) 5/16 Flat
Washers (8) Rubber Feet
Assembly Instructions
Traditional Picnic Tables
2
3. Locate the Table Supports and insert the rubber
plugs into the two outer hole on the supports
4. Lay the Table Top face down on a so work
surface.
5. Take the Table Support and line the holes up
with the mounting holes on the Table Top.
6. Using one bolt, two washers, and one nut for
each hole, attach the Table Suppport to the
Table Top. Hand tighten to secure the part.
7. Locate a Cross Brace. Align the cross brace with
the connecting point on the Table Support and
the Table Top.
8. Attach the Cross Brace to the Table Support and
the Table Top using one bolt, two washers, and
one nut. Hand tighten to secure the part.
9. Repeat Steps 5 through 8 for each remaining
Cross Brace and Table Support.
Assembly Instructions
Traditional Picnic Tables
3
• Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability
• Furniture that is damaged or appears to be unstable must be removed from service and repaired or replaced
• Repairs must be made using only factory authorized parts and methods.
WARNING
• Do not drag the assembled unit across any surface.
• This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to remove
surface dirt. Do not clean with a solvent or petroleum based products.
CARE AND
MAINTENANCE
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
03/27/2023 Manufactured in the U.S.Copyright 2023 Anova®
10. Take the long seat and align the seat with the
arm on the Table Support.
11. Secure it to the Supports with one bolt, two
washers, and one nut per hole and hand
tighten.
12. Locate the ADA Bench and align the seat with
the opposing arm of the Table Supports.
13. Secure the ADA Bench using one bolt, two
washers, and one nut per hole and hand
tighten.
14. Repeat Steps 12 and 13 with the second ADA
Bench.
-
1
-
2
-
3
Anova T1038R Assembly Instruction
- Type
- Assembly Instruction
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Anova RCPG6 Assembly Instruction
-
-
-
-
-
-
-
-
-
Other documents
-
Gorilla Playsets Riverview Installation guide
-
Creative Cedar Designs 3201 Operating instructions
-
Creative Cedar Designs 3200 Operating instructions
-
-
-
-
-
-
-
