Z-Wave Wall Controller SR-ZV9003T3-RGBW-US

Safety & Warnings

•

• DO NOT expose the device to moisture.

Quick Start

How to install:

• Step 1: turn on your wall controller.

• Step 2: activate inclusion mode on your Z-Wave controller.

• Step 3: activate inclusion mode of your wall controller by pressing the

network will act as repeaters regardless of vendor to increase reliability of the network.

Although it is controlling other devices, the device cannot act as Z-Wave network

controller (primary or secondary), so a security enabled controller is needed for take full

advantage of all functionally for the device. It also supports the Over The Air (OTA)

feature for the product’s firmware upgrade.

The wall controller has following functions:

1.Control of groups of other Z-Wave devices using 'ON', 'OFF', Dim and Color Control

commands.

2.Activation of scenes in Gateways.

The encryption modes that the wall controller supports are S0, S2 Unauthenticated.

Power Supply

Power Consumption

Operating temperature

Relative humidity

Inclusion/Exclusion” Button

Installation Guide

Please read carefully the enclosed user manual before installation of wall controller, in

order to ensure an error-free functioning.

AC Power input

83.00 mm

L L N N

PRI:

Uin=100-240VAC

Iin=15mA MAX

Out=Z-Wave Signal

size wall boxes.

ATTENTION: Only authorized technicians under consideration of the country specific

2. Make sure the wall controller does not belong to any Z-Wave network (please refer to

the part “How to check whether the wall controller included to a network” of this manual).

3. Short press the “inclusion/exclusion” button, or press and hold down “ALL ON/OFF”

button for over 3 seconds, the wall controller will be set to inclusion mode, and waiting to

be included, then LED indicator turns on and blinks 6 times quickly to indicate

successful inclusion.

Once the wall controller quits “inclusion mode”, the LED indicator will turns off. There

are 3 methods for the wall controller to quit “inclusion mode”:

1. Automatically quits after successful inclusion.

2. Quits after 25 seconds timeout.

controllers manual on how to set your controller into exclusion).

2. Short press the “inclusion/exclusion” button, or press and hold down “ALL ON/OFF”

button for over 3 seconds, the wall controller will be set to exclusion mode, and waiting

to be excluded, then LED indicator turns on and shows 3 short blinks and 1 long blink to

indicate successful exclusion.

Once the wall controller quits “exclusion mode”, the LED indicator will turns off. There

are 3 methods for the wall controller to quit “exclusion mode”:

1. Automatically quits after successful exclusion.

2. Quits after 25 seconds timeout.

3. Press and hold down “ALL ON/OFF” button for over 3 seconds, or short press the

Note: Factory reset is not recommended for exclusion, please use this procedure only if

indication means the wall controller does not belong to any network.

If the wall controller already belongs to a network, follow the exclusion process before

including it in your network. Otherwise inclusion of this device will fail.

Factory Reset

Press and hold down “inclusion/exclusion” button for over 8 seconds, LED indicator

blinks slowly to indicate successful factory reset, release “inclusion/exclusion” button,

the wall controller will restart automatically.

Association

Z-Wave devices control other Z-Wave devices. The relationship between one device

controlling another device is called association. In order to control a different device, the

associated with multiple groups on the wall controller simultaneously, to ensure better

control experience, the wall controller shall remove the associated devices that are not

under working status from association groups in time.

1.Send “Command Class Device Reset

Locally” to associated devices of this group

to report factory reset information when

factory reset the wall controller.

the associated devices with a Basic Set

commands.

2.Press PWM1-PWM4 buttons, direct

control of associated devices using Color

Switch Set commands.

1

Lifeline

Launch 1

12

Press button "2" to activate group.