SD-Direct Card Reader Installation Guide
Nov 2006 MICRODIA Ltd.
For Windows Users
To install the FlashMover
®
SD-Direct Card Reader on Windows 2000/XP:
1. Plug the card reader into your computer USB port.
2. It is fully Plug-&-Play for Windows 2000/XP, no driver installation needed.
3. A new removable drive is added to your computer after plug in the card reader.
4. Insert SD
TM
/MMC
TM
Card to access files in your card.
NOTE: Please check MICRODIA
®
website, www.microdia.com, for downloading the latest driver.
For Macintosh Users
To install the FlashMover
®
SD-Direct Card Reader on Mac OS 9/X and above
1. Plug the card reader into your computer USB port.
2. It is fully Plug-&-Play for Mac OS9/X and above, no driver installation needed.
3. A new removable drive is added to your computer after plug in the card reader.
4. Insert SD
TM
/MMC
TM
Card to access files in your card.
NOTE:
- Please check MICRODIA
®
website, www.microdia.com, for downloading the latest driver.
- Please go to Mac website to update the latest version of Mac OS.
Removing your SD
TM
card from the FlashMover
®
SD-Direct Card Reader
To remove the SD
TM
/MMC
TM
card on Windows system
1. Close any files that are opened and reside on the SD
TM
/MMC
TM
card.
2. You can remove your card safely after the LED stop blinking
To remove the SD
TM
/MMC
TM
card on Mac system
1. The SD
TM
/MMC
TM
card must be [EJECTED] or [UN-MOUNTED] by dragging the card’s disk icon in the trash.
CAUTION: Failure to properly [EJECT] the card before removing the card from the card reader could case data loss
or corruption.
Most problems or technical issues can be resolved by simply visiting our Support Section in MICRODIA
®
website,
www.microdia.com