Microdia SD+USB Operating instructions

Brand: Microdia

Model: SD+USB

Type: Operating instructions

MICRODIA Ltd

Email: [email protected]

Website: http://www.microdia.com

+USB MEMORY CARD

OPERATING MANUAL

SPECIFICATIONS CONFIRMATION OF PARTS LIST

Dimension: 24.0 (W) x 32.0 (L) x 2.1 (T) mm

Weight: Approx. 2g

Operating Voltage: 2.7 to 3.6 V

Operating Temperature:

-25°C to +85°C

Clock Frequency: Up to 25MB/sec

Operating Humidity: 5% to 96% RH

+USB memory card

Plastic Case Manual

NOTE: Specifications are subject to change without notice.

REMOVAL oOF THE SD

+USB CARD FROM BLISTER

1. Hold a corner of the blister.

2. Clap the blister on your palm for removing the plastic case.

3. Hold the blister upside down with about an inch of distance

between the blister and the table.

4. Use your finger to push the edge of the SD

+USB card.

5. Then SD

+USB card will drop on the table.

Step 1 & 2 Step 3 & 4 Step 5

REMOVAL AND STORAGE OF THE SD

+USB CARD IN PLASTIC CASE

1. Hold the case with both hands when opening and closing.

2. Unlock and open the lid of the case.

3. Store or remove the SD

+USB card in the tray. Ensure the card

is placed properly on the tray before closing the case.

4. Lock the plastic case.

Step 2 Step 3

PRECAUTIONS FOR HANDLING AND STORAGE

• Keep out of the reach of children. Get medical advice immediately if swallowed.

• Do not touch the interface pin directly by hands, metal or hard objects.

• Do not modify or disassemble the SD

+USB card.

• Do not wet, heat/fire, impact, drop or bend the SD

+USB card.

• Do not use or store in a humid and dusty place; in hot place such as inside a hot car, under a blazing sun, near

fire, a stove, an air-conditioner outlet, etc.

• Do not expose to strong magnet fields, electrical noise and put near corrosive chemicals/gas. This may cause

damage through melting or the emission of heat/smoke or cause product failure.

• Do not place in cooking appliances such as microwave ovens or high-pressure containers.

• Do not detach the label on the SD

+USB card. Do not attach other stickers/labels on the SD

+USB card.

DATA PROTECTION

• MICRODIA SD

+USB Memory Card comes pre-formatted. Make sure to back up all the data on your

SD+USB card before formatting.

• Slide down Write-Protect Switch to “LOCK” for preventing record/edit the card. Unlock the card before

reading/writing data.

Unlock Lock

• Do not remove the SD

+USB card and switch off any equipment using the card when data is being read,

written and transferred. It can cause data to be destroyed.

• Insert the SD

+USB card firmly in the correct orientation. The product will not operate correctly if it is

inserted in an incorrect orientation or not inserted all the way

• Parental Guidance is needed when a child uses the SD

+USB card. Teach the child how to use and

protect the product and insure that the child follows your instructions.

Microdia SD+USB Operating instructions

Microdia SD+USB Operating instructions

Microdia SD+USB Operating instructions

Related papers

Other documents