2. BLOTZ
  3. B10-CS-256

BLOTZ B10-CS-256 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Hospital Middle B10-CS-256 model. This document details the assembly process for creating a 10mm scale, L-shaped hospital mid-section. It covers using glue, a modeling knife, and other techniques to build the model correctly. I'm ready to answer any questions you have about this model and its construction based on the provided document.
  • What type of glue is required for assembly?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while glue dries?
10mm 5x5 ‘L-Shape’ Hospital Middle
B10-CS-256
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-CS-256)
Remove walls ‘A’ to ‘F’ from the sprue, along with
the framework. Starting with wall ‘A’ glue them
to the framework, working clockwise around the
model. Leave to dry.
Attach the wall coverings to walls ‘D’, then ‘E’ before
attaching the rest of the wall coverings.
Remove the six rectangular supports from the
sprue and glue one to the back of each wall
section (at the base of the wall) as shown above.
The finished middle section.
/