2. GrimmSpeed
  3. 15-21 WRX/STI Fender Shrouds

GrimmSpeed 15-21 WRX/STI Fender Shrouds Installation guide

  • Hello! I've reviewed the GrimmSpeed installation guide for the 15+ Subaru WRX/STI Fender Shrouds. This document details the simple process, using basic tools for installation of the fender shrouds. I am ready to answer your questions about this product and its installation procedure.
  • What tools are needed for installation?
    How long does it take to install the fender shrouds?
    What do I do with the OEM fender liner?
GrimmSpeed Install Guide Series
Installing the GrimmSpeed 15+ Subaru WRX/STI Fender Shrouds
Updated 8/20/19
Introduction:
This guide will illustrate the installation of the GrimmSpeed 2015+ WRX/STI Fender Shrouds. The difficulty here is
easy, so take your time and enjoy the job! Expect to spend 5-10 mins, depending on level of experience.
Tools:
The tools listed below are suggested for this task.
• 4mm Allen Wrench
• Flathead Screwdriver
Take care to follow the installation instructions carefully!
If you have any questions don’t hesitate to contact us directly!
[email protected] | 612-379-0000
Black PART# 096049
Red PART# 096048
Procedure:
1. Begin by collecting your tools.
2. Pop your hood and locate the two pop clips on your OEM fender liner
3. Use your flathead screwdriver to pop the clips and remove them.
4. With the clips removed, you can remove the OEM fender liner.
5. Repeat the same steps for the other side.
6. Fit your new fender shroud into place by lining up the mounting holes to the fender.
7. Reuse an OEM pop clip on the top mounting hole.
8. Use included hardware to secure the Shroud in place.
9. Tighten the nut and bolt using a 4mm allen wrench.
10. Repeat the same steps when installing on the driver side.
11. You are done! Enjoy your new GrimmSpeed Fender Shrouds!
If you have any questions don’t hesitate to contact us directly!
[email protected] | 612-379-0000
/