BLOTZ B00-RT-229 Assembly Instructions

Fantasy Football Dugout

B00-RT-229

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the base and two long wall sections from the

sprue.

Also take two of the wall support sets from the

sprue.

Glue the long wall in place (with the holes being on the

inside of the dugout, then attach the wall supports

into place as shown.

Take one set of side walls (see above) from the

sprue.

Glue these into place as shown. Repeat this with the

other end of the dugout.

Take the short side wall pieces shown.

Glue them into place as shown. Repear this at the

other end of the dugout.

Take the two shorter walls.

Glue them into place as shown (holes on the inside of

the dugout), then take the two sets of end walls.

Glue them into place as shown.

Glue the other pair of wall supports into place.

The steps should be glued together so the thin step

in central on the larger step.

Glue the steps into the entryways as shown.

Take the wall toppers from the sprue.

Glue them into place.

The finished dugout

Download PDF