Fantasy Football Dugout
B00-RT-229
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base and two long wall sections from the
sprue.
Also take two of the wall support sets from the
sprue.
Glue the long wall in place (with the holes being on the
inside of the dugout, then attach the wall supports
into place as shown.
Take one set of side walls (see above) from the
sprue.
Glue these into place as shown. Repeat this with the
other end of the dugout.
Take the short side wall pieces shown.
Glue them into place as shown. Repear this at the
other end of the dugout.
Take the two shorter walls.
Glue them into place as shown (holes on the inside of
the dugout), then take the two sets of end walls.
Glue them into place as shown.
Glue the other pair of wall supports into place.
The steps should be glued together so the thin step
in central on the larger step.
Glue the steps into the entryways as shown.
Take the wall toppers from the sprue.
Glue them into place.
The finished dugout
/
