Amerec T100 Mounting Template

Brand
Amerec
Model
T100
Type
Mounting Template
4211-xxx 07-29-11
T100 MOUNTING TEMPLATE
Step1: Drill four 3/4" holes spaced as shown below.
Hole pattern must be level and plumb as shown.
2-5/8"
3/4"
2-5/8"
"5"5
NOTE: If you are printing these instructions, make sure acrobat's print scaling is set to NONE.
Measure your printed instructions to ensure they are printed to the correct scale before use as a template!
(67mm)
(67mm)
(127mm)(127mm)
(19mm)
4211-xxx 07-29-11
T100 MOUNTING TEMPLATE
CUT
CUT
CUT
CUT
Step2: Cut straight edges from hole to hole as shown.
NOTE: If you are printing these instructions, make sure acrobat's print scaling is set to NONE.
Measure your printed instructions to ensure they are printed to the correct scale! before use as a template!
  • Page 1 1
  • Page 2 2

Amerec T100 Mounting Template

Brand
Amerec
Model
T100
Type
Mounting Template
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents