Page is loading ...
Installing WeR@Home
TM
in three easy steps
1
Set up the hub
2
The WeR@Home
TM
app
Download the WeR@Home
TM
iOS or
Android app. Follow the on-screen
instructions to register the hub.
The app assigns a default PIN code
of 1234.
Scan to download
the app
Menu
Quick access
Status
Arming buttons
Info center
The LED on the front
of the hub lights green
5
Insert the battery
1
Connect the power cable and
plug in to a power source
3
4
Connect to your internet router
Connect the Z-Wave Extender
2
Connect the power cable and
plug in to a power source
Without Z-Wave
With Z-Wave
OR
3
ESUG05165 Rev. 1.0
2
Align the two units
using the dots
1
Open the sensor and
insert the battery
3
Peel off the protective strips
4
Press one unit on the door
or window and the other
on the frame
Press any button a few times to discharge the device
Open the battery cover
In the app, tap and then DEVICES.
Tap Add device,select Remote Control, and assign a user
Insert the battery and close the cover
To install additional devices: in the app, tap and then DEVICES. Tap Add device, and follow the on-screen instructions.
2 5
For more information about installing and using the WeR@Home
TM
system, see http://www.essence-grp.com/resources/smart-living-download.html
1
Remove the mounting base
and insert the batteries
2
Replace the mounting base and
peel the strips off the adhesive tape
3
Press the siren against the wall
3
Install the peripheral devices
Remove the mounting base
1
Remove the back cover
(camera only) and insert
the batteries
2
Peel off the strips.
Only use the adhesive tape
needed for the installation
(flat wall or corner)
3
Press the mounting base
against the wall or corner and
insert the device
4
Motion Detector
Camera
● Between 2.1 m (6.9 ft.) to
2.3 m (7.5 ft.) high
● A clean, dry, smooth, and
flat wall, or in a corner
● Spherical lens facing
downward
● Not facing windows,
sunlight, or a strong light
source
● Within 6 m (20 ft.) of the
coverage area
www.essence-grp.com • [email protected]
© 2018 All rights reserved to Essence Security International (E.S.I.) Ltd.
Location:
1
2
3
4
5
Install the door/window sensor
Register the remote control (key fob)
Install the siren
Install the camera and motion detector
Legal notice: http://www.essence-grp.com/html/concerning_documents.html
For installing
in a corner
For installing
on a flat wall
/
