To start using your Essence HD
Camera, follow these easy steps
Indoor HD Pan/Tilt Camera
(ES800HDP-M01)
Getting Started
1
Where to place the camera
Within Wi-Fi or
cable range
Not in direct
sunlight
Near power
supply
No extreme
temperatures
2
3
Attach the cables
Add the camera to WeR@Home™
Optional: Insert formatted SD card
Connect ethernet
cable (RJ45)
Connect power
cable
Open the WeR@Home™ app
Tap
Tap DEVICES
Tap Add device
Tap HD Camera
Follow the on-screen instructions
For wireless use: Tap Configure and then Wi-Fi Network.
If the WeR@Home app can’t find the camera:
1. Ensure that smartphone and camera are
connected to the same network
2. Use the the tip of a pen to press and hold
the RESET button for 5 seconds. Wait 30
seconds and try again
1
2
3
4
6
5
7
For more information about installing and using the WeR@Home
TM
system,
see http://www.essence-grp.com/resources/smart-living-download.htm
l
www.essence-grp.com • [email protected]
© 2018 All rights reserved to Essence Security International (E.S.I.) Ltd.
Legal notice: http://www.essence-grp.com/html/concerning_documents.html
ESUG05155 Rev. 1.0
4
Mount the camera (optional)
Mark drill sites with holes in base
Drill holes
Insert anchors
Attach mount to wall or ceiling with screws
Press the camera base against the mount.
Turn the camera clockwise until it clicks
into place.
Base
Mount
1
2
3
4
5
/
