ACCESSORY INSTALLATION
INSTRUCTIONS
BOW CUSHION
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/10/2010
Rev:B
PROCEDURE NO.
AI-MS-004
8. PROCEDURE
8.1. Lay the cushion in place.
8.2. Starting on the corner of the cushion, and using the pencil,
make a mark on the deck just under each snap on the
underside perimeter of the cushion.
8.3. Remove the cushion and using the 1/8” drill bit
w/countersink, drill and slightly countersink at each mark
Made in previous step.
8.4. Apply silicone to each of the holes drilled in the previous step.
8.5. Using the drill with Phillips head bit, insert a snap receiver into
each of the holes drilled in the previous step.
Page 2 of 3