2. KC HiLiTES
  3. Flex Quad LED Lights

KC HiLiTES Flex Quad LED Lights User manual

  • Hello! I have analyzed the provided installation instructions for the KC FLEX ERA 3 Trim, Lens, and O-Ring. The document details the steps for proper installation, including tool requirements, screw torque specifications, and the use of lock-tite. I am ready to answer any questions you have about this process.
  • What tool is needed to remove the M4 Flat Socket Cap Screws?
    What should I do with the screws after removing them?
    What is the recommended torque for the screws?
TRIM INSTALLATION: LENS + O-RING INSTALLATION:
Begin by using a 2.5 Hex/Allen Key to remove the M4 Flat
Socket Cap Screws.
Begin by using a 2.5 Hex/Allen Key to remove the M4 Flat
Socket Cap Screws.
Remove BEZEL & TRIM from the assembly ONLY, leaving the
LENS & O-RING in place.
Remove BEZEL, TRIM, LENS + O-RING from the assembly.
Re-place the TRIM by seating it atop of the LENS.
Place ‘new’ O-RING in side the O-Ring Groove in Housing.
Place LENS atop the O-RING with the correct logo positioning.
Re-place the BEZEL over the TRIM.
Remove and Re-apply (Blue) Lock-Tite onto the screws.
Remove and Re-apply (Blue) Lock-Tite onto the screws.
Re-place the BEZEL over the TRIM.
Re-place the TRIM over the LENS.
Hand-tighten the M4 Flat Socket Cap Screw, evenly
distributing the pressure.
Torque the Screws to 6.5lbf.in (7.5kgf.cm)
Hand-tighten the M4 Flat Socket Cap Screw, evenly
distributing the pressure.
Torque the Screws to 6.5lbf.in (7.5kgf.cm)
1. 1.
2. 2.
3.
3.
4.
4.
5.
7.
6.
5.
6.
8.
STEP BY STEP INSTALLATION INSTRUCTIONS
IT IS HIGHLY RECOMMENDED THAT ALL SERVICING OF LED
MODULES OCCUR OFF THE VEHICLE AND ON A CLEAN,
FLAT SURFACE.
INSTALLATION INSTRUCTIONS
KC FLEX™ ERA 3
TRIM | LENS + O-RING
Copyright 2020 KC HiLiTES, Inc. Rev:05192020 - KC3265COA REV 1
IMPORTANT:
Please read all instructions before beginning installation. These guidelines are provided in good faith to help prevent any issues arising from errors during installation. The
manufacturer of this product shall not be held responsible for any user actions taken or not taken during installation. There are many details of the installation that are assumed
to be general mechanical knowledge to experienced installers; which are not detailed in these instructions. These installation guidelines are intended to serve as professional
recommendations and are not as a step-by-step, fail-safe installation checklist. Selection of an experienced installer is the sole responsibility of the project owner.
/