2. KC HiLiTES
  3. 50" Overhead Xross Bar Light Mount

KC HiLiTES 50" Overhead Xross Bar Light Mount Installation guide

  • Hello, I'm a chat assistant that has read the KC HiLiTES Mounting Instructions document for the LED light bar C50 and Mounting bracket set. The document provides detailed, step-by-step instructions for mounting the brackets and light bar. If you have any questions about the installation process or the components included, I'm here to help.
  • What parts are included in the package?
    How many bolts need to be removed to mount the brackets?
    What is the last step after mounting the brackets?
Thanks for choosing KC HiLiTES products; your satisfaction is very important to us. if you have any questions
regarding this product or any other KC HiLiTES products, please contact us at (888) 689-5955 or visit kchilites.com.
PARTS INCLUDED
1 - 50” LED light bar with wiring
1 - Above windshield light mounting bracket set
10 - M8 x 1.25 x 30 mm Black Zinc Bolts
10 - M8 Black Zinc Washers
2 - Protective Rubber Gaskets
MOUNTING THE BRACKETS
1. Remove the upper five of the six Torx head bolts from
each of the windshield frame brackets. These are
located in the lower corner of the driver and
passenger side of the windshield.
2. Align the rubber protective gasket with the holes on
the vehicle and secure temporarily with small pieces
of scotch tape or similar.
3. Place the bracket on the gasket and start each of the
five M8 bolts and washers. Tighten all by hand.
Remove the tape used to secure and then tighten all
bolts.
4. Repeat procedure for opposite side of vehicle.
5. Install your 50” C50 LED bar to the brackets and wire
it according to the instructions included with the LED
bar.
YOU’RE DONE
KC HiLiTES, Inc., Williams, AZ USA 888-689-5955 www.kchilites.com KC3265AW v20170803
Mounting Instructions for
50” LED Bars & Windshield
Mount Bracket Set for Jeep JK
Remove
these
5 bolts.
/