2. FSR
  3. PWB-CMU8
PWB-CMU8

FSR PWB-CMU8 Installation guide

  • Hello! I've reviewed the Installation Instructions for the FSR PWB-CMU8-2PLT Wall Box. This document details how to install the wall box, modify the concrete blocks, and perform the electrical connections, including the installation of a divider and customer-provided cover plates. I'm ready to answer any questions you have about the installation process or its features.
  • What should be done with the construction cover before applying mortar?
    What is the purpose of the construction cover?
    What is provided by the customer?
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - FAX 973.785.4207
PWB-CMU8-2PLT Installation Instructions
LIT186543451
MODIFIED CONCRETE BLOCK
2.5"
CONCRETE BLOCK
WALL BOX
CONSTRUCTION COVER
CONCRETE BLOCK
PWB-CMU8
SURFACE FLUSH WITH 2.5" MODIFIED
CONDUITS AND CONDUIT
FITTINGS AS REQUIRED
WALL BOX INSTALLATION
REMOVE CONSTRUCTION COVER FROM BOX. INSERT CONDUIT FITTINGS AND CONDUIT INTO BOX. RE-1.
INSERT CONSTRUCTION COVER WITH SUPPLIED HARDWARE BEFORE ANY MORTAR IS APPLIED TO THE
BOX.
A MODIFIED CONCRETE BLOCK WILL NEED TO BE CUT AS SHOWN BELOW. 2.
PLACE THE WALL BOX ON THE BLOCK WALL, ENSURING THE FRONT SURFACE OF THE WALL BOX IS FLUSH
3.
WITH CONCRETE BLOCK WALL. ENSURE MORTAR IS APPLIED TO TOP, BOTTOM, SIDES AND ALL BLOCK
WEBS. ALL SEAMS AROUND THE WALL BOX SHOULD BE FILLED WITH MORTAR.
NOTE** IT IS IMPORTANT THAT THE CONSTRUCTION COVER IS INSTALLED ON WALL BOX PRIOR TO PLACING THE WALL BOX
ON THE BLOCK WALL AND BEFORE ANY CONCRETE BLOCKS ARE PLACED ABOVE THE UNIT.
BLOCKS
MODIFIED
CONCRETE
16"
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - FAX 973.785.4207
PWB-CMU8-2PLT Installation Instructions
LIT186543451
DIVIDER
70/30
8x #6-32 SCREW
(SEE BACK)
COVER
DIVIDER
COVER
2x #6-32 SCREW
PWB-CMU8 (WALL NOT
SHOWN FOR CLARITY)
TYPICAL COVER/DIVIDER INSTALLATION
DIVIDER
DIVIDER
DIVIDER
AND LOCAL ELECTRICAL CODES.
ELECTRICAL INSTALLATION
AFTER MORTAR HAS SET REMOVE AND DISCARD CONSTRUCTION COVER AND HARDWARE. 1.
DETERMINE DIVIDER LOCATION AND INSTALL DIVIDER WITH HARDWARE PROVIDED.2.
COVERS ARE TO BE PROVIDED BY THE CUSTOMER. A DXF IS PROVIDED ON FSR'S WEBSITE, TO BE USED 3.
AS A GUIDELINE IN THE MANUFACTURING OF THE COVER PLATES. DETERMINE WHICH SET OF COVERS
IS NEEDED BASED ON THE LOCATION OF THE DIVIDER, USE THE CORRESPONDING DXF'S PROVIDED.
INSTALL COVERS WITH HARDWARE PROVIDED.
NOTICE: FOR INSTALLATION BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL NATIONAL
4 POSSIBLE DIVIDER LOCATIONS
60/40
/