STEP BY STEP
229
STEP 59-1
Fit one of the Rotoex bearing seals 1
(59B) to one of the Rotoex bearing
seals 2 (59C), inserting the pin into the
hole. Press the two halves together.
Repeat with the second set of seals.
STEP 59-3
Place the Rotoex coupling left (59E),
marked with the letter L, on the
reverse side of the previous assembly,
aligning the three holes with the ends
of the mount posts.
STEP 59-2
Insert the three posts of one of
the Rotoex coupling mounts
(59D) into the corresponding
holes in the seal assemblies.
STEP 59-4
Secure the parts together with
three FP02 screws.
59-E
59-B
59-C
59-B/59-C
59-B/59-C
59-E
59-D
59-D
Pin
Post
FP02
Hole
Hole