Push Button DT6 DALI Group Controller 09.2402K4G.04859
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Rotary Switch for Assigning
Group (Total 16 Groups)
DA DA
DALI INPUT
DALI signal output
Back side
59.3 mm
80 mm
59.3 mm
80 mm
9mm 17.6mm
DA DA
DALI INPUT
Output DALI signal
Operation Current 30mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 80x80x26.6mm
Product Data
Power Supply Supply By DALI Bus
Wiring Diagram
DALI signal
DA DA
DALI BUS
DALI DT6 Device
DALI DT6 Device
DA
DA
DA
DA
Installation
• DO NOT installed with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
• DALI DT6 push button controller
• Ultra slim and luxury design
• Material and finishing color can be customized
• With back lighting design, easy to find even in dark night
• DALI bus powered, no extra power supply required
• Each channel DALI bus can install multiple controllers
• Enables to select and control 2 DALI groups from total 16
DALI groups
• Easy installation with mounting bracket
• Waterproof grade: IP20
Group 1:
Click to switch on group.
Press and hold down to turn
up brightness of group.
Group 1:
Click to switch off group.
Press and hold down to turn
down brightness of group.
Group 2 Group 2
1. Do wiring according to connection diagram correctly.
2. Set starting Group number via rotary switch on the back: (0-15 selectable)
• This DALI push button controller enables dimming commands to be sent to Two Groups of devices on the
DALI circuit by two groups of buttons. A rotary switch on the back is used to select DALI Groups you would like
to control and set the starting Group number, and total 16 Groups (0-15) can be selected.
• When the rotary switch arrow position is at 0, Group 1 buttons controls all devices on DALI circuit through
broadcast, Group 2 buttons controls DALI group 0.
• When the rotary switch arrow position is at X except 0 (1-15), Group 1 buttons controls DALI Group X-1,
Group 2 buttons controls DALI Group X.
For example: Rotary switch arrow at 1, Group 1 buttons controls DALI Group 0, Group 2 buttons controls DALI
Group 1. Rotary switch arrow at 15, Group 1 buttons controls DALI Group 14, Group 2 buttons controls DALI
Group 15.
Please refer to the detailed Group setting table as follows:
Rotary Switch
Position
DALI Group for
Group 1 Buttons
0
Broadcast
1
0
2
1
3
2
4
3
5
4
6
5
7
6
8
7
9
8
10
9
11
10
12
11
13
12
14
13
15
14
Operation
DALI Group for
Group 2 Buttons 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Note: please assign the devices on DALI circuit to a DALI group(0-15) with DALI master controller first.
/
