Sunricher SR-2410RG-RGB-GL User manual

Type
User manual
Backlighting, turns on/off
as the controller turns
on/off, light intensity
changes as the controller
light intensity changes,
color changes as the
controller RGB color
changes, blinks twice as
the controller switches
between light intensity and
CCT adjustment
DT6/DT8 Group Control RGB DALI Rotary Controller 09.2410RG.04013
Function introduction
Important: Read All Instructions Prior to Installation
Output DALI signal
Operation Current 4mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions
Product Data
Power Supply Supply By DALI Bus
Rotary Switch for Assigning
Group (Total 16 Groups)
Wiring Diagram
D1 D2
DALI I NPUT
D1
D2
DALI Bus
Click to turn ON/OFF, rotate
clockwise/counterclockwis
e to increase/decrease light
intensity, double click to
switch from light intensity
adjustment to RGB color
adjustment, then rotate to
select RGB color
Front side
55.57 mm
71.20 mm
Back side
55.57 mm
71.20 mm
The remote control can be
fixed on the wall with 3M
glue or screw.
D1 D2
DALI INPUT
DALI signal output
55.6 x 55.6 x 20.8 mm
17.5 mm
123
4
GND
AC Power
50/60Hz
L
N
G
V+
V-
OUTPUT
INPUT
12V/24V/36V
CV PSU
123
4
GND
DO NOT install with power applied to device.
DO NOT expose the device to moisture.
Safety & Warnings
Comply to DALI standard protocol IEC 62386-102, IEC
62386-207, IEC 62386-209 and in compliance with DALI
products from other international incorporation.
• Support DALI DT8 devices, Control of DT8 devices with
three channels output for red, green and blue via DALI
(DT8, color reproduction RGBWAF).
• DALI bus powered, one channel DALI bus can install
multiple dimming controllers.
• No external power supply which is provided by DALI
bus. Consumption current is 4mA.
• Enable to select and control 1 DALI group.
• Enable to control all devices on the DALI circuit through
broadcast.
• Plastic or glass front plate optional.
• Backlighting design to indicate the dimming status.
Conn ect with RGB LED St rip
V+ V+
R- R-
G- G-
B- B-
Conn ect with RGB LED St rip
V+ V+
R- R-
G- G-
B- B-
1. Do wiring according to connection diagram correctly.
2. Set starting Group number via rotary switch on the back: (0-15 selectable)
This DALI rotary controller enables dimming and color adjusting commands to be sent to One Group of
devices on the DALI circuit by one Group of button. A rotary switch on the back is used to select Group you
would like to control and set the starting Group number, and total 16 Groups (0-15) can be selected.
When the rotary switch arrow position is at 0, the controller controls all 16 Groups of devices through
broadcast.
When the rotary switch arrow position is at X except 0 (1-15), the controller controls Group X-1 of devices.
For example: Rotary switch arrow at 1, it controls Group 0 of devices. Rotary switch arrow at 15, it controls
Group 14 of devices.
Please refer to the detailed Group setting table as follows:
Rotary Switch
Position
DALI Group for
the controller
0
Broadcast
1
0
2
1
3
2
4
3
5
4
6
5
7
6
8
7
9
8
10
9
11
10
12
11
13
12
14
13
15
14
Operation
  • Page 1 1
  • Page 2 2

Sunricher SR-2410RG-RGB-GL User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI