2. FSR
  3. SF8-SPC1

FSR SF8-SPC1, SF8-SPC7 Installation guide

  • Hello! I've reviewed the provided installation instructions for the FL-500P/600P SF8-C Adapter Plate. The document outlines the steps involved in installing the plate, including removing a temporary cover, applying sealant, and securing the adapter with screws and o-rings. I understand that a shim kit might be necessary to adjust the box’s height. I’m ready to address any questions you might have regarding the installation process.
  • What should I do with the temporary cover?
    What should I do after installing cable interfaces and connector plates?
    Can the SF8 adapter plate be installed in any orientation?
FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43241 LIT1592
1. WHEN READY TO INSTALL SF8 COVER, REMOVE AND DISCARD
TEMPORARY COVER AND SCREWS.
TEMPORARY COVER
(8) FLAT HEAD SCREW
2. INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY
NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF
BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
ADAPTER PLATE
(8) O-RING
(8) FLAT HEAD SCREW
3. INSTALL SF8 ADAPTER PLATE (CAN BE ROTATED 180°) WITH SUPPLIED
O-RINGS AND FLAT HEAD SCREWS. REFER TO SF8 COVER INSTALLATION
INSTRUCTIONS TO COMPLETE INSTALLATION.
FL-500P/600P-SF8-C ADAPTER PLATE INSTALLATION INSTRUCTIONS
NOTE: COVER SHIM KIT (FL-500P-CSK OR
FL-600P-CSK) MAY BE REQUIRED TO
SET THE HEIGHT OF BOX "PRE-POUR"
SO THE TOP OF FINISH COVER
MATCHES TOP OF FINISHED FLOOR.
/