FSR SF8-SPC1 Installation guide

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207

43241 LIT1592

1. WHEN READY TO INSTALL SF8 COVER, REMOVE AND DISCARD

TEMPORARY COVER AND SCREWS.

TEMPORARY COVER

(8) FLAT HEAD SCREW

2. INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY

NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF

BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.

CLEAN AND APPLY SEALANT

AROUND ENTIRE EDGE

CLEAN AND APPLY SEALANT

AROUND ENTIRE EDGE

ADAPTER PLATE

(8) O-RING

(8) FLAT HEAD SCREW

3. INSTALL SF8 ADAPTER PLATE (CAN BE ROTATED 180°) WITH SUPPLIED

O-RINGS AND FLAT HEAD SCREWS. REFER TO SF8 COVER INSTALLATION

INSTRUCTIONS TO COMPLETE INSTALLATION.

FL-500P/600P-SF8-C ADAPTER PLATE INSTALLATION INSTRUCTIONS

NOTE: COVER SHIM KIT (FL-500P-CSK OR

FL-600P-CSK) MAY BE REQUIRED TO

SET THE HEIGHT OF BOX "PRE-POUR"

SO THE TOP OF FINISH COVER

MATCHES TOP OF FINISHED FLOOR.

This manual is also suitable for

Download PDF