2. BLOTZ
  3. B10-ME-203

BLOTZ B10-ME-203 Assembly Instructions

  • Hello! I have analyzed the user manual for the 10mm Ancient City Wall - Tower. This document provides detailed, step-by-step instructions on how to assemble the model, including the use of glue, knife and optional parts like doors. I'm ready to answer any specific questions you might have about the tower's construction process.
  • What type of glue is required?
    What tool is required to remove parts from sprue?
    Can I use sandpaper?
10mm Ancient City Wall - Tower
B10-ME-203
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Take the supports.
Glue them into position.
Take the walkway and rear wall.
Turn the walkway over and attach the two sub-
assembles to it. The slopes should be next to the line
of lugs on the walkway.
Turn the model right side up and add the rear
wall.
Then attach the base.
Glue the side walls into position.
Take the two sections of the front wall.
Add them to the model.
[Optional] The doors.
[Optional] Glue the doors into place.
Take the floor and side supports from the sprue.
Glue them together as shown.
Take the walls with the lugs on the ends.
Glue them in front of the supports, then add the other
two walls.
Take the roof and side supports.
Glue them together as shown.
Take the wall pieces.
Glue the walls with the lugs in front of the side
supports, then add the other two wall pieces.
The decorative strips.
Glue these into place.
The front of the finished model.
The back of the finished model.
/