1MLM 104 Faceplates • Installation Guide
MLM 104 Faceplates Installation Guide
MLM 104 Faceplates
This guide provides instructions for installing the following Extron MediaLink
™
Mounting Options faceplates, which are designed for use with MLC 104 IP Plus
MediaLink Controllers.
The MLM 104 L, MLM 104 2GWP, or MLM 104 4GWP faceplate is shipped
with the MLC 104 IP Plus controller, depending on the controller configuration
that is ordered. The rest of the mounting options described below may be
ordered separately as replacements, or for use with an MLC 104 IP Plus that is
ordered without a faceplate.
• MLM 104 L — A low-profile, 3.15" H x 6.50" W (8.0 cm H x 16.5 cm W)
lectern/furniture-mounting faceplate. This faceplate is required when you are
mounting an MLC 104 IP Plus using an optional UCM RAAP or UCM 10X8P
mounting kit.
Part numbers: 70-357-02 (black), 70-357-03 (white), 70-357-05 (RAL9010 white)
• MLM 104 LAAP — A low-profile, 3.15" H x 10.00" W (8.0 cm H x 25.40 cm W)
lectern/furniture-mounting faceplate with an opening that accommodates
four single-space AAPs
Part numbers: 70-358-02 (black), 70-358-03 (white), 70-358-05 (RAL9010 white)
68-878-01, Rev. D
08 07
MLM 104 Faceplates Installation Guide, cont’d
MLM 104 Faceplates • Installation Guide2
• MLM 104 2GWP — A two-gang (4.50" H x 4.60" W [11.43 cm H x 11.68 cm W])
faceplate that can be mounted to a mud ring (mounting bracket), an Extron
Surface Mount Box, an Extron External Wall Box, or a standard electrical box
Part numbers: 70-378-02 (black), 70-378-03 (white), 70-378-05 (RAL9010 white)
• MLM 104 4GWP — A four-gang (4.50" H x 8.23" W [11.43 cm H x 20.9 cm W])
faceplate with an opening that accommodates four single-space AAPs. It can
be mounted to a mud ring, an Extron Surface Mount Box, an Extron External
Wall Box, or a standard electrical box.
Part numbers: 70-379-02 (black), 70-379-03 (white), 70-379-05 (RAL9010 white)
• MLM 104 6GWP— A six-gang (4.50" H x 11.75" W [11.43 cm H x 29.85 cm W])
faceplate with two openings that accommodate four single-space AAPs each
(eight AAPs total). It can be mounted to a mud ring, an Extron Surface Mount
Box, an Extron External Wall Box, or a standard electrical box.
Part numbers: 70-355-02 (black), 70-355-03 (white), 70-355-05 (RAL9010 white)
3MLM 104 Faceplates • Installation Guide
Replacing the MLC 104 IP Plus Faceplate with an MLM
Faceplate
1. If your MLC controller is already installed in a wall or furniture, remove the
four screws that attach it to its mounting surface (marked
a
in the diagram
below), and lift it out.
2. After the MLC has been removed from the wall or furniture, use a small
Phillips screwdriver to remove the four faceplate attachment screws (marked
b
in the diagram below), and save them for later use.
CAUTION
Do not remove the four faceplate screws while the MLC is installed in a
wall or furniture, or the controller may fall into the wall or furniture.
CONFIG
DISPLAY
VOLUME
ON
OFF
1
2
3
4
2
2
2
2
MLC 104 IP PLUS
VCR
DVD
PC
1
1
1
1
3. Lift the faceplate off the MLC 104 IP Plus, as shown below.
O
FF
O
N
O
FF
O
N
VCR
DVD
PC
Extron
C
O
N
F
IG
DISPLAY
VOLUME
1
2
3
4
MLC 104 IP PLUS
MLM 104 Faceplates Installation Guide, cont’d
MLM 104 Faceplates • Installation Guide4
4. Align the openings in the new MLM faceplate with the controller’s buttons,
knob, and LEDs, then place the new faceplate on the MLC 104 IP Plus.
5. Replace the four screws removed in step 2, and hand tighten them.
6. Install the MLC 104 IP Plus controller in a wall or furniture as appropriate.
Templates
Use one of the following templates as a guide to measure and mark the hole for
installing the MLM 104 faceplate with an attached MLC 104 IP Plus. (Refer to your
MLC 104 IP User’s Manual for instructions on preparing the mounting site.)
CAUTION
These templates are not to scale. Use the dimensions shown in the
templates as reference guidelines for measuring and drawing the rectangle
that will be cut out.
The MLC controller requires a depth of at least 2.0" (5.1 cm) inside the wall or
furniture.
5MLM 104 Faceplates • Installation Guide
MLM 104 L and MLC 104 IP Plus L template
.295" (0.75 cm)
.250" (0.64 cm)
6.5"
(16.5 cm)
Cut-Out Template for Extron's MLM 104 L
and MLC 104 IP Plus L
TEMPLATE IS NOT FULL SIZE.
To install MLC 104 IP Plus
and MLM 104 L
directly into furniture,
cut along this line.
Top Panel
2.8"
(7.1 cm)
3.5"
(8.9 cm)
SURFACE CUT-OUT AREA
FOR FURNITURE MOUNT
3.15"
(8.0 cm)
Location of
MLC 104 IP Plus
MLM 104 Faceplates Installation Guide, cont’d
MLM 104 Faceplates • Installation Guide6
MLM 104 LAAP template
2.8"
(7.1 cm)
7.9"
(20.1 cm)
SURFACE CUT-OUT
AREA FOR
FURNITURE MOUNT
10"
(25.4 cm)
Cut-Out Template for Extron's MLM 104 LAAP
TEMPLATE IS NOT FULL SIZE.
To install the MLC 104 IP Plus
and the MLM 104 LAAP
directly into furniture,
cut along this line.
Top Panel
Location of MLC 104 IP Plus
3.15"
(8.0 cm)
.295" (0.75 cm)
.250" (0.64 cm)
7MLM 104 Faceplates • Installation Guide
MLM 104 2GWP and MLC 104 IP Plus template
4.6"
(11.7 cm)
Cut-Out Template for Extron's MLM 104 2GWP
and MLC 104 IP Plus
TEMPLATE IS NOT FULL SIZE.
To install MLC 104 IP Plus
and MLM 104 2GWP
directly into furniture,
cut along this line.
Top Panel
2.8"
(7.1 cm)
3.5"
(8.9 cm)
SURFACE CUT-OUT AREA
FOR FURNITURE MOUNT
4.5"
(11.4 cm)
Location of MLC 104 IP Plus
MLM 104 Faceplates Installation Guide, cont’d
MLM 104 Faceplates • Installation Guide8
MLM 104 4GWP and MLC 104 IP Plus AAP template
2.8"
(7.1 cm)
7.1"
(18.0 cm)
SURFACE CUT-OUT
AREA FOR
FURNITURE MOUNT
8.23"
(20.9 cm)
Cut-Out Template for Extron's MLM 104 4GWP
and MLC 104 IP Plus AAP
TEMPLATE IS NOT FULL SIZE.
To install the MLC 104 IP Plus
and the MLM 104 4GWP
directly into furniture,
cut along this line.
Top Panel
Location of MLC 104 IP Plus
4.5"
(11.4 cm)
9MLM 104 Faceplates • Installation Guide
2.8"
(7.1 cm)
11.0"
(27.9 cm)
SURFACE CUT-OUT
AREA FOR
FURNITURE MOUNT
Cut-Out Template for Extron's MLM 104 6GWP
TEMPLATE IS NOT FULL SIZE.
Top Panel
Location of MLC 104 IP Plus
11.752"
(29.85 cm)
To install the MLC 104 IP Plus
and the MLM 104 6GWP
directly into furniture,
cut along this line.
4.5"
(11.4 cm)
MLM 104 6GWP template
© 2007 Extron Electronics. All rights reserved.
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
800.633.9876 714.491.1500
FAX 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort, The Netherlands
+800.3987.6673 +31.33.453.4040
FAX +31.33.453.4050
Extron Electronics, Japan
Kyodo Building, 16 Ichibancho
Chiyoda-ku, Tokyo 102-0082
Japan
+81.3.3511.7655 FAX +81.3.3511.7656
Extron Electronics, Asia
135 Joo Seng Rd. #04-01
PM Industrial Bldg., Singapore 368363
+800.7339.8766 +65.6383.4400
FAX +65.6383.4664
www.extron.com
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
Extron electronic MLM 104 4GWP User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron electronics IR Link User manual
-
Extron electronics MLC 52 RS MK User manual
-
Extron AAP 103 AKM UK User manual
-
Extron electronics V-LockTM User manual
-
Extron electronics MLC 104 IP Plus User manual
-
Extron electronic MLC 62 RS EU User manual
-
Extron Extron Electronics Stereo System SCP 226 User manual
-
-
-
Other documents
-
Extron MLC 226 IP Template
-
Extron MLC 62 RS EU Owner's manual
-
-
-
-
-
Extron MLC 62 RS CC User manual
-
-
-