AVFI PD51-EBT Assembly Guide

Assembly Instructions

PD51/PD5103/PD5107 Console

This document shows how to dismount and mount the console from the PD51, PD5107 Stations and PD5103 Podium.

As well as how to remove the front console panel from a wedge position.

Note: If you cannot understand these instructions or are concerned about safety of the installation contact a qualified

contractor or contact AVFI at 1-877-834-3876

www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876

Tools required

To remove front console panel, pull firm and evenly by holding the panel from the grommet holes. The

fasteners will unlock.

Push in the same manner to reattach the panel.

Note: Panel can also be removed by pushing up from the inside if there are special cuts or if devices cover the grommet holes.

4mm Hex Allen key

Supplied Hardware

Vent grill (2)

Lift and remove console

Reverse the procedure to mount back the console

Insert vent grills

into the slots

Remove bolts from both sides