Elac MSB41L 3 Channel Passive Soundbar for TV 65-Inch and Large Owner's manual

Elac
Brand
Elac
Model
MSB41L 3 Channel Passive Soundbar for TV 65-Inch and Large
Category
Soundbar speakers
Type
Owner's manual
MSB41S 3 CHANNEL PASSIVE SOUNDBAR FOR TV’s 55” and larger
OPERATING INSTRUCTIONS
Muro
Muro
Muro
Muro
MSB41L 3 CHANNEL PASSIVE SOUNDBAR FOR TV’s 65” and larger
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 1
Safety Instructions
1. General information
• Please read and follow these safety instructions.
• Keep them safe for future reference.
• Observe all warnings on the soundbar and in the manual. Please check the soundbar for damage before
use. The soundbar must be in perfect working condition.
2. Use only as directed
• Connect the soundbar according to the instructions in the manual.
3. Location
• Install the soundbar on the wall or on a level surface only
• When choosing the location of the soundbar do not place the unit in locations that are:
• In direct sunlight
• Very humid
• Prone to vibrations
• Exceptionally hot or cold
• Near CRT Televisions (the speakers inside the soundbar are not magnetically shielded and may
cause color issues with a CRT based TV)
• Close to magnetic cards (Since the speakers inside the soundbar are not magnetically shielded
placing magnetic cards such as credit cards or commuter cards may cause them to fail).
WARNING! Please ensure the product is perfectly stable to avoid injury from tip-over. Do not install the soundbar
near any heat sources such as radiators, heating valves, stoves, or other apparatus that produce heat, or in
areas where there is a risk of explosion.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not put burning candles on or near the soundbar.
• Do not install the soundbar near transformers, because electromagnetic stray fields can cause hum
noise .
4. Overload
Extreme overload of the device due to very high volume may cause damage to individual components.
Because of the possible danger, you should never leave the soundbar under extreme overload
conditions unattended.
5. Service
DANGER! Do not open the soundbar because the components and conductors may carry current!
Servicing to be carried out by qualified service personnel only.
Servicing is required when the soundbar has been damaged in any way, such as damage when liquid
has been spilled or objects have fallen onto the soundbar, the soundbar has been exposed to rain or
moisture, does not operate normally, or has been dropped. Servicing should be carried out by qualified
service personnel only.
6. Cleaning
NOTE: Clean only with soft, smooth cloth or with dust brush. Do not use scouring agents, alcohol,
benzene, furniture polish or other agents for cleaning! Modern furniture is often coated with multiple
varnishes and plastics which can be treated with chemical agents.
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 2
7. Volume
CAUTION! Continuous high volume may cause severe damage to your hearing. Please listen responsibly.
8. Disposal
The packaging is made from recyclable materials. Dispose of this in an environmentally friendly manner.
At end of life do not dispose of the soundbar with standard household waste. The product must be
recycled in accordance with local legislation. Ask your local government for further information on
recycling as the device contains valuable raw materials.
Philosophy
Thank you for purchasing this ELAC product.
Since the time we started (1926), ELAC has always striven to achieve the very best.
Your new ELAC pasive soundbar is built to the highest standards using high-quality components that are
carefully constructed to deliver the best-in-class sound quality. The soundbar has been developed by a
passionate group of individuals whose soul purpose is to bring a new dimension of sound quality into your
home. Enjoy!
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 3
Wall Mounting of the Passive Soundbar
Avoid damage to the soundbar and other components:
• Carefully unbox the soundbar to avoid physically damaging the unit.
• Depending on your existing audio-video configuration it is recommended to carefully choose the
channel connection (left - center - right) of the passive soundbar..
• Both soundbar models can be mounted on the wall using the provided wall bracket.
• Use the provided wall bracket as a template to mark up on the wall the location of the holes.
• The wall bracket is the same for both soundbar models MSB41L and MSB41S . See Fig.1.
• The design of the soundbar and wall bracket allow you to adjust the position of the soundbar by 1.77 in
[4.5 cm] in both directions: left and right from the center axis of the wall bracket. See Fig.2 and Fig.3.
• The adjustment left and right of the soundbar allows you to better align the soundbar with the TV unit
above.
Fig.2
[34.45 cm]
87.5 in
[3.62 cm]
9.2 in
[2.83 cm]
7.2 in
[0.12 cm]
R0.3 in
[8.18 cm]
20.78 in
[8.18 cm]
20.78 in
[8.18 cm]
20.78 in
[8.18 cm]
20.78 in
Fig.1
[60.52 cm]
153.73
in
[5.91 cm]
15 in
[4.5 cm]
1.77 in
[4.5 cm]
1.77 in
[50.23 cm]
127.58
in
[5.91 cm]
15 in
[4.5 cm]
1.77 in
[4.5 cm]
1.77 in
Fig.3
MSB41S
MSB41L
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 4
Soundbar Connection
After choosing the position of the soundbar, do the following to avoid damaging the soundbar:
• Ensure your equipment is turned o before connecting the soundbar.
• Use appropriate gauge wires (minimum of 16 gauge wire for runs up to 25 feet).
• Connect the left, center and right channel output terminals of your audio source to the appropriate
soundbar binding posts as shown in Fig.4.
• Make sure wire polarity is connected correctly. Most speaker cables are coded for ease of use. Make
sure positive (red) connection on the audio source terminal is connected to the positive (red) on your
soundbar. Follow the same instructions for the negative side. Strip o approximately 1/2”of the insulation
from the ends of the speaker cable, twist the bare strands and insert into the binding post.
• Check to ensure positive and negative wires are not touching each other once they’re connected to the
soundbar terminals. See Fig.4.
Fig.4
View from the back of passive soundbar
Installing and Removing the Grill
The mesh grill of your passive soundbar is designed to be removable if desired. To remove it, hold the top or
bottom edges of the grill and pull gently. To install the grill, align the edges of the grills with the edges of the
soundbar. The grill will be positioned and hold in place by the magnets incorporated in the grill.
Center
Channel
Terminals
Left
Channel
Terminals
Right
Channel
Terminals
Audio Source Output Terminals
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 5
On-Wall Soundbar Setup
The Elac MSB41L and MSB41S passive soundbars are designed to be mounted on the wall primarily, but you can
also place them on a horizontal surface of a piece of furniture under your TV.
If you choose the on-wall mounting of the soundbar, you should allow a minimum distance of 1 inch [2.5 cm]
between the upper edge of the wall bracket and your TV. See Fig.5.
We highly suggest that a professional installer performs the on-wall installation of passive soundbar. Dierent
wall materials require dierent types of mounting hardware.
Specifications
Parameter / Model MSB41S MSB41L
Speaker Type Passive Radiator Passive Radiator
Tweeter 1” Soft Dome x 3 1” Soft Dome x 3
Woofer 4” Aluminum x 8 4” Aluminum x 8
Frequency Response 75Hz - 35000Hz 70Hz - 35000Hz
Crossover Frequency 2800Hz 2800Hz
Sensitivity 86db @ 2.83 v/1m 86db @ 2.83 v/1m
Max Power Input 80 Watts 80 Watts
Nominal Impedance 6 Ohms 6 Ohms
Biding Posts Metal Push Metal Push
Cabinet Finish Satin Black or Satin White Satin Black or Satin White
Grill Black/Grey Magnetic Black/Grey Magnetic
Wall Mount Included Included
Height 5-15/16” 5-15/16”
Width 50-3/16” 60-1/2”
Depth 3-7/16” 3-7/16”
Net Weight 26.23 lbs 28.66 lbs
Fig.5
1.0 in [2.5 cm] min
TV
ELAC MSB41L / MSB41S PASSIVE SOUNDBAR | www.elac.com | Page 6
ELAC AMERICAS INC.
11145 KNOTT AVE. SUITES E & F
CYPRESS, CA 90630
ELAC ELECTROACUSTIC GMBH
FRAUNHOFERSTRAßE 16
D-24118 KIEL, GERMANY
Warranty
North America Limited Liability Warranty
ELAC Americas Inc. warrants to the original purchaser that this product be free from defects and or workmanship
for a period of 1 (One) year on the soundbar from the original date of purchase.
During this time period, repair or replacement of parts will be free of charge to the original owner (See below
limitations). Shipping to and return from the repair center will be the responsibility of the original purchaser.
Limitations
Warranty begins on the date of original purchase from an authorized ELAC Americas Inc. dealer.
• Product is warranted only if used in home applications. Commercial use of this product is not warranted.
• Product that has been modified or altered in anyway will not be warranted.
• Product that has been abused or subjected to faulty equipment will not be warranted.
• Products with defaced or removed serial numbers will not be warranted.
If service is required
In the event that service is required, please contact ELAC America at 714-252-8843 or at
[email protected] to arrange for service or replacement. You will be responsible to provide proof of
purchase (Copy or original sales receipt). Shipping to and from our repair center will be the responsibility of the
original purchaser.
Warranty Outside of North America
This warranty applies to products purchased in the United States and Canada. For warranty claims outside of
North America please contact the local dealer/distributor in the country of purchase.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Elac MSB41L 3 Channel Passive Soundbar for TV 65-Inch and Large Owner's manual

Elac
Brand
Elac
Model
MSB41L 3 Channel Passive Soundbar for TV 65-Inch and Large
Category
Soundbar speakers
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents