2. ITC
  3. 69770-FF-KK

ITC 69770-FF-KK User manual

  • Hello! I've analyzed the provided installation instructions for the Scene Light 69770-FF-KK which includes information about mounting, wiring, and important safety steps. I'm ready to answer any questions you have about the device or the installation process.
  • What parts and tools are needed for installation?
    What is the recommended fuse protection?
    What should be avoided when applying sealant?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00147 • Rev A • 11/09/2022
PARTS/TOOLS NEEDED:
Screws Provided Butt Splices & Application
Specific Sealant
(Not Provided)
Nova™ Scene Light Power Drill
(Not Provided)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
2. Follow the wiring diagram below to wire the light to
your system.
INSTALLATION INSTRUCTIONS
Nova™ Scene Light
Part#: 69770-FF-KK
Page 1 of 1
1. Determine the installation location and drill hole for
wires then align the light with gasket in the wire hole
and use the light to mark screw holes. Drill appropriate
sized holes for mounting screws.
3. Feed the wires back through the hole and use applica-
tion specific sealant in the specified circles areas both
below and on top of the rubber. NOTE: Be sure the
sealant does not block the heat sink channels.
4. Press the light onto the rubber gasket then screw the
light in place.
Scene Light
To 12V DC
Power
Black (-)Red (+)Black (-)
4. Place the bezel on the light and push until it snaps into place.
/