ALLEGION Legge 990MF Installation guide

ALLEGION
Brand
ALLEGION
Model
Legge 990MF
Type
Installation guide
Right Hand
OPENING IN
OPENING OUT
Outside
Outside
Left Hand
OPENING OUT
OPENING IN
990MF Handing/Function Adjustment
V Series handing adjustment (Inside handle free)
To set for left hand
Push in and turn clockwise. Set adjuster as shown.
To set for right hand
Push in and turn anti-clockwise. Set adjuster as
shown.
V9/V10/V55/V56
The Locking Bar must be down before installing.
D & S Series Deadlocks & Sliding door locks
Set adjuster as shown.
To set for C Series (Both handles lockable)
Supplied unhanded. Fit cylinder or turn adaptor to
appropriate sides. When only one cylinder or turn is
used fit plug into unused hole.
V SERIES
LH
FREE
LOCKABLE
V SERIES
RH
FREE
LOCKABLE
C SERIES
LOCKABLE
Handing/Function
Adjuster
1.
To Reverse Bolt
2.
Remove outer forend.
Handing Guide
Pull & rotate bolt through 180° clockwise.
Allegion (New Zealand) Limited
Phone 0800 477 869
Website www.allegion.co.nz 12/2013
Allegion (Australia) Pty Ltd
Phone 1800 098 094
Website www.allegion.com.au
990MF Mortice Lock
Installation Instructions
DEPTH OF MORTICE IS 92MM FOR 60MM BACKSETDEPTH OF MORTICE IS 92MM FOR 60MM BACKSET
Centre
of lock
ALL FUNCTIONS EXCEPT NIGHT TURN WITH EMERGENCY
LATCH OR EMERGENCY RELEASE RELEASE (N SERIES)
NIGHT LATCHES
To suit
furniture
Edge
of bolt
1.
Mortice Instructions
2.
Cut mortice slot using template for correct size.
3.
Fit lock into mortice, scribe around forend and remove
wood to allow flush fit to door.
Hole 20mm
Cylinder
Cylinder
Hole 20mm
Remove lock and use template to mark and drill holes to
suit lock and furniture being used.
TOP TOP
Turn
Hole 20mm
Turn
Hole 20mm
Spindle
Hole 22mm
Spindle
Hole 22mm
60mm Backset
70mm Backset
89mm Backset
127mm Backset
60mm Backset
70mm Backset
89mm Backset
127mm Backset
6.5mm holes for
horizontal fixed rose
furniture only at
41.0mm centres.
6.5mm holes for
horizontal fixed rose
furniture only at
41.0mm centres.
6.5mm holes for horizontal
fixed rose furniture only at
38.0mm centres.
6.5mm holes for horizontal
fixed rose furniture only at
38.0mm centres.
2 x 6.5mm holes for diagonal
fixed rose furniture only at
50.8mm centres.
2 x 6.5mm holes for diagonal
fixed rose furniture only at
50.8mm centres.
IMPORTANT
A MAXIMUM CLEARANCE OF 5mm IS RECOMMENDED BETWEEN
LOCK FOREND AND STRIKER PLATE FOR SECURITY REASONS.
CHECK CAREFULLY:
DO NOT DRILL HOLES RIGHT
THROUGH DOOR. THE
FURNITURE MAY NOT COVER
ANY HOLES THAT ARE
INCORRECTLY DRILLED.
990MF LOCKS ARE DESIGNED FOR USE WITH SPRUNG DOOR
FURNITURE. THE USE OF UNSPRUNG DOOR FURNITURE IS NOT
RECOMMENDED.
  • Page 1 1
  • Page 2 2

ALLEGION Legge 990MF Installation guide

ALLEGION
Brand
ALLEGION
Model
Legge 990MF
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents