sylvan E64 Installation guide

Brand
sylvan
Model
E64
Type
Installation guide
P: +64 9 444 5359 F: +64 9 444 3972 sales@gdrutter.co.nz www.sylvan.co.nz
Lever FurnitureInstallation InstructionsInstallation Template
SYLE64DT001
42mm
For 70mm backset fold here
For 60mm backset fold here
Drill 2.5mm holes x 2
5mm Deep
1 2
3 4
Mark and drill door.
Start approx 990mm from the floor, fold and apply the
supplied template and mark 2 centre points at your
desired backset of 60mm or 70mm. Using a 2.5mm drill
bit, drill to a depth of 5mm using the marked holes.
Remove the Lever from base.
Using the pin supplied, press the anchor
point and remove the lever from the base.
Install the Lever.
Place the rose on the door aligning the holes
with the pre-drilled holes and insert x2 supplied
screws, install the rose firmly placing over the base
until set. The install the Lever by placing over
the base and slide on until it clicks.
Remove the Rose from base.
Using the supplied install driver, depress the
rose anchor point and pull the rose to remove from
the base.
Square
door
edge
Place template on
high edge of bevel door
Mark centre of door
Bevel
door
edge
Installation for E64 Dummy Trim
With this fixed dummy set we recommend using our MC1 Magnet, visit our website for further information.
  • Page 1 1

sylvan E64 Installation guide

Brand
sylvan
Model
E64
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents