Midmark Modular Installation guide

Brand: Midmark

Model: Modular

Type: Installation guide

This manual is also suitable for

Ritter - Modular

1© Midmark Corporation 2006

MA568802

Tab

Adjustment Plate

Rear

Screws

Front

Screw

003-1652-00 Rev. (A)

18" & 36" Task Light Installation

For models:

RC (Ritter)

MC (Midmark)

Step 2: Loosen rear screws until

adjustment plate slides freely.

Step 3: Insert mounting bracket tab

into slot in back of light housing.

Secure bracket to housing

with front screw & lockwasher.

Repeat for other bracket.

Step 4: Position front of mounting brackets

on lip under front edge of cabinet.

Slide adjustment plates so they rest

securely on lip under rear edge of cabinet.

Tighten rear screws.

Hardwire Applications:

Hardwire applications require a licensed electrician

to connect the three wires (hot, neutral, ground) to

the facility electrical system. A conduit hole is

provided in back of light housing.

All applicable local codes must be adhered to.

Daisy Chain Applications:

The daisy chain option allows up to ten lights to be

wired together using a single supply source. Each

fixture can be turned On / Off independently. The

first light must be a DCP (daisy chain w/power

cord).The specifier must indicate whether a power

cord (DCP), or jumper cord (DCJ) is required for

additional fixtures.

Note

Discard the mounting instructions

from Light Corp.

Step 1: Remove diffuser panel & bulb.

Step 6: Plug into appropriate115V receptacle.

(If power cord supplied.) Otherwise refer

to Hardware or Daisy Chain Application.

Note: There is a 1/4" hole in each mtg. bracket

for cable ties to secure power cord.

Step 5: Install diffuser panel & bulb.

Style A

1

Midmark Modular Installation guide

Brand: Midmark

Model: Modular

Type: Installation guide

This manual is also suitable for

Ritter - Modular

Download PDF

Related papers

Other documents