Angelo Decor AD93015 Operating instructions

Thank you for buying an Angelo Decor Fountain!

We hope you will find these instructions helpful in setting up your fountain. If you need more

information to properly care for your fountain, please DO NOT return the unit to place of purchase.

Please visit our web site, www.angelodecor.com, for assistance and warranty information.

First unpack carton carefully, arranging parts safely in your working area.

Pump is pre-installed with Pump is set to full. Pump should sit flat and

Reduce flow if lower splash is desired. move free inside pump house

Use the supplied tubing and connector to Run tubing through Twist and lock riser to

connect to the top water feature middle riser section. the top section.

Twist and lock riser to Connect tubing to the pump. Install the pump access door.

pump house. Place inside sitting flat on bottom.

Final Assembly should

look like this

Install spill bucket using grooves.

Position bucket so it will spill

forward.

Now simply fill with clean water and plug into a grounded GFCI outlet

We recommend keeping bowl 3/4 full of water to avoid pump burnout.

seal. Check to be sure it is tight