Angelo Decor AD93110 Operating instructions

Thank you for buying an Angelo Decor Fountain!

We ho

ou will find these instructions hel

ful in settin

our fountain. If

ou need mor

information to

erl

care for

our fountain,

lease DO NOT return the unit to

lace of

urchase.

Please visit our web site, www.an

elodecor.com, for assistance and warrant

information.

First unpack carton carefully, arranging parts safely in your working area.

Pump comes pre-installed Set pump to desired Feed the cord down through the Twist and Lock bowl in place.

with cord seal,Check to see setting. pedestal and align with groove at base.

the cord seal is tight

Connect tubing to pump.

Run tubing up through the riser. "Twist and lock" riser in place. Run tubing through the 2nd tie

Connect tubing to top sectio

"Twist and lock" bowl in place. "Twist and lock" top piece into

place.

Install pump access door. The final assembly should

look like this

This fountain comes complete with

our innovative splash reduction

system. If splash is a concern,

simply drape the splash line over

each spill point to dramatically

reduce splash.

Now sim

fill with clean water and

into a

rounded GFCI outle

We recommend keeping bowl 3/4 full of water to avoid pump burnout.