Page is loading ...
Thank you for buying an Angelo Decor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Lay out all parts in your
work area. Feed the light cord and tubing
from the top orb through the
opening in the middle section of
the fountain as shown.
Pull the excess cord from
the light out the bottom
of
Pass the light cord and the cord from the
pump through the cord pipe in the
Carefully set the orb on top of the middle
section of the fountain as shown above.
The light should sit as shown.
Connect the tubing from the
light to the "Y" connector
Now simply fill with clean water and plu
g
into a
g
rounded GFCI outle
t
We recommend keepin
g
bowl 3/4 full of water to avoid pump burnout.
Product must be properly stored for winter.
Lay out all parts in your
work area. Feed the light cord and tubing
from the top orb through the
opening in the middle section of
the fountain as shown.
Attach the light cord to the
transformer.
Pull the excess cord from
the light out the bottom of
the fountain.
Pass the light cord and the cord from the
pump through the cord pipe in the
reservoir and align with the groove at the
base.
The final assembly should
look like this
Place the cord pipe cover
over the pipe and cords
as shown above.
Connect the tubing to the
pump and adjust the pump
to your desired setting.
Carefully set the orb on top of the middle
section of the fountain as shown above.
The light should sit as shown.
Connect the tubing from the
light to the "Y" connector.
Carefully place the
assembled top and
middle parts of the
fountain on to the
/
