Danfoss BasicGrip - Cement screed User guide

Application sheet

BasicGrip

Carpet / tiles / parquet / laminate / synthetics

Cement-screed

1 Carpet / tiles / parquet

2 Cement-screed 65 mm

3 FH composite pipe (16 mm)

4 BasicGrip panel 11mm insulation 11 mm

5 Insulation WLG 040 40 mm

6 Basic perimeter insulation

Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics

Construction height 116 mm Height excluding oor nish

Weight ~ 138 kg / m² Weight excluding oor nish

Thermal resistance R 1,31 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is

fullled.

Thermal transmission coecient U 0,76 W / m²K If the architectural design species better thermal insulation, this

must be taken into account.

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

The R value must be increased if the groundwater level is less than or equal to 5 m. A

U value not exceeding 0.5 W/m²K must be maintained in existing buildings and addi-

tions with areas up to 50 m². Structural sealing according to DIN 18195 must be placed

beneath the oor panel in case of structures facing the ground, and otherwise on the

unnished oor. The screed thicknesses must be adjusted in case of higher design load

or point load values.

Observe all installation instructions and manufacturer’s instructions.

Additional insulation

Insulation: 40 mm EPS 040 DEO

Construction

According to EnEV, EN 1264, DIN 4109, 1055 and 18560

Construction number 170

Technical Data Floors/ceilings facing unheated rooms or the ground

VA.CT.T1.02

Danfoss HES